Re: USB not accepting addresses in bk9

[Greg KH]

On Thu, May 15, 2003 at 12:00:03AM -0400, David van Hoose wrote:
> Sometime between 2.5.69-bk4 and 2.5.69-bk8, something with related to 
> the USB was messed up. I get the below lines in my dmesg.
> hub 2-0:0: new USB device on port 1, assigned address 2
> usb 2-1: USB device not accepting new address=2 (error=-110)
> hub 2-0:0: new USB device on port 1, assigned address 3
> usb 2-1: USB device not accepting new address=3 (error=-110)
> 
> The first device is my Logitech Cordless Optical Trackball.
> The second device is my TI USB Graphlink.
> 
> The Trackball still works. Not sure about the graphlink as I don't have 
> the software installed yet. :-/

How can the device work if the USB bus rejected it?  Also, does
/proc/interrupts increment for the USB controller when you plug a device
in?

> I used the same config for bk4 as I did for bk8. It've attached my 
> config for bk9 since it is the same anyway.

Care to do a binary search of bk4 to bk8 to try to find the problem?
Should only take you 2 reboots at most :)

thanks,

greg k-h