How to fix: PCI: No IRQ known for interrupt pin A of device 00:11.1.

[Simon Posnjak]

Hi,

At boot up I get:

Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller on PCI bus 00 dev 89
PCI: No IRQ known for interrupt pin A of device 00:11.1.
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt8235 (rev 00) IDE UDMA133 controller on pci00:11.1
    ide0: BM-DMA at 0xe400-0xe407, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xe408-0xe40f, BIOS settings: hdc:DMA, hdd:DMA
hda: WDC WD800JB-00CRA1, ATA DISK drive

I would like to fix the: PCI: No IRQ known for interrupt pin A of device
00:11.1. message. because I think that this is the route of all my
problems(disk not working at full speed, audio flickering,...).

I use RedHat's 2.4.18-19.8.0 kernel (This message is all so in
2.4.21pre3-ac4) on Kudzo 7x mboard with VIA KT400(vt8235).

Can some body pleas tell me what exactly is the problem and what should
I do to fix it.

	Regards Simon