>On Fri, Jul 19, 2002 at 09:26:07PM +0200, Thomas Langås wrote:
>
>
>>qla2x00_set_info starts at address = f8836060
>>qla2x00: Found VID=1077 DID=2200 SSVID=1077 SSDID=2
>>scsi1: Found a QLA2200 @ bus 2, device 0x4, irq 16, iobase 0xdc00
>>scsi(1): Allocated 4096 SRB(s)
>>PCI: Setting latency timer of device 02:04.0 to 64
>>scsi(1): Configure NVRAM parameters...
>>scsi(1): 64 Bit PCI Addressing Enabled
>>scsi(1): Verifying loaded RISC code...
>>scsi(1): Verifying chip...
>>scsi(1): Waiting for LIP to complete...
>>scsi(1): Cable is unplugged...
>>qla2x00: Found VID=1077 DID=2200 SSVID=1077 SSDID=2
>>scsi2: Found a QLA2200 @ bus 2, device 0x5, irq 17, iobase 0xd800
>>scsi(2): Allocated 4096 SRB(s)
>>PCI: Setting latency timer of device 02:05.0 to 64
>>scsi(2): Configure NVRAM parameters...
>>scsi(2): 64 Bit PCI Addressing Enabled
>>scsi(2): Verifying loaded RISC code...
>>scsi(2): Verifying chip...
>>scsi(2): Waiting for LIP to complete...
>>scsi(2): Cable is unplugged...
>>
I have an HSG80 connected on the other side and I got this problem with
the beta6 drivers from qlogic.
The only way I made it working was using the kernel driver shipped with
rh7.3
that has been modified to support the HSG80 (according to the changelog
supported
only by the beta6 series).
Fabio
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/