Re: int. assignment on SMP + ServerWorks chipset

[Petr Matula]

On Wed, Jan 17, 2001 at 01:33:42PM -0800, Linus Torvalds wrote:
> Did you also remove the two lines that disabled pirq routing if an IO-APIC
> was enabled?
Yesterday not, today yes. But it's the same.

> > Kernel with these changes can't detect my SCSI drive. It prints these messages 
> > in cycle:
> 
> Which SCSI adapter is this? It may be that you have one of the drivers
> that does not do "pci_enable_dev()" at initialization time..
SCSI storage controller: Adaptec 7899P (rev 0).
  IRQ 16.
  Master Capable.  Latency=72.  Min Gnt=40.Max Lat=25.
  I/O at 0x5800 [0x58ff].
  Non-prefetchable 64 bit memory at 0xfd000000 [0xfd000fff].

Used kernel options:
CONFIG_SCSI=y
CONFIG_BLK_DEV_SD=y
CONFIG_SD_EXTRA_DEVS=40
CONFIG_SCSI_DEBUG_QUEUES=y
CONFIG_SCSI_CONSTANTS=y
CONFIG_SCSI_AIC7XXX=y
CONFIG_AIC7XXX_CMDS_PER_DEVICE=8
CONFIG_AIC7XXX_RESET_DELAY=10

Petr

---------------------------------------------------------------
 Petr Matula                                    [e-mail]
                                    http://www.fi.muni.cz/~pem
---------------------------------------------------------------