Re: Any experience with Promise PDC20376 and SATA RAID?

[Carl-Daniel Hailfinger]

Reid Spencer wrote:
> I think the kernel doesn't know about the device number (105a:3376 =
> PDC20376) since it isn't in the kernel's drivers/pci/pci.ids file
> (latest device is 7275 PDC20277)and it doesn't recognize the device when
> it processes the IDE devices at boot up. All I get is:
> 
> ide: Assuming 33MHz system bus speed for PIO modes; override with
> idebus=xx
> VP_IDE: IDE controller at PCI slot 00:11.1
> VP_IDE: chipset revision 6
> VP_IDE: not 100% native mode: will probe irqs later
> VP_IDE: VIA vt8235 (rev 00) IDE UDMA133 controller on pci00:11.1
>     ide0: BM-DMA at 0xa400-0xa407, BIOS settings: hda:DMA, hdb:pio
>     ide1: BM-DMA at 0xa408-0xa40f, BIOS settings: hdc:DMA, hdd:pio
> hda: WDC WD400AB-32BVA0, ATA DISK drive
> blk: queue c03c58e0, I/O limit 4095Mb (mask 0xffffffff)
> hdc: ATAPI 52X CDROM, ATAPI CD/DVD-ROM drive
> ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> ide1 at 0x170-0x177,0x376 on irq 15
> hda: attached ide-disk driver.
> hda: host protected area => 1
> hda: 78165360 sectors (40021 MB) w/2048KiB Cache, CHS=4865/255/63,
> UDMA(100)
> ide-floppy driver 0.99.newide
> Partition check:
>  hda: hda1 hda2 hda3 hda4 < hda5 hda6 hda7 hda8 hda9 >
> ide-floppy driver 0.99.newide
> 
> Note that ide2 isn't found even though I specifically gave the ports for
> it on the "append line" of the boot.  I don't know enough about the
> IDE/PDC support to be able to add support for this new PDC20376 chip.
> 
> Anyone out there done this?
> 
> Reid.
>