Best Regards
Michael
On Friday 11 April 2003 15:39, Jarmo Järvenpää wrote:
> Indeed we have the same problem.
>
> This gives a bit of headache, hda1 and hdc1 are software raid 1 array
> and sometimes one disk is dropped from the array due "error" on the
> disk.
> Hotadd will succeed and no bad blocks on either disk. No problems with
> 2.4.18. Not tested with .19 nor .20.
>
>
> BR,
> Jarmo
>
>
> Kernel 2.4.2.21-pre6
>
> lspci:
> 00:00.0 Host bridge: Intel Corp. 440LX/EX - 82443LX/EX Host bridge (rev
> 03)
> 00:01.0 PCI bridge: Intel Corp. 440LX/EX - 82443LX/EX AGP bridge (rev
> 03)
> 00:07.0 ISA bridge: Intel Corp. 82371AB/EB/MB PIIX4 ISA (rev 01)
> 00:07.1 IDE interface: Intel Corp. 82371AB/EB/MB PIIX4 IDE (rev 01)
> 00:07.2 USB Controller: Intel Corp. 82371AB/EB/MB PIIX4 USB (rev 01)
> 00:07.3 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ACPI (rev 01)
> 00:0e.0 VGA compatible controller: Matrox Graphics, Inc. MGA 2164W
> [Millennium II]
> 00:10.0 Ethernet controller: 3Com Corporation 3c905B 100BaseTX [Cyclone]
> (rev 30)
>
>
> dmesg:
> ide: Assuming 33MHz system bus speed for PIO modes; override with
> idebus=xx
> PIIX4: IDE controller at PCI slot 00:07.1
> PIIX4: chipset revision 1
> PIIX4: not 100% native mode: will probe irqs later
> ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:pio
> ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:pio
> hda: QUANTUM FIREBALL_TM3200A, ATA DISK drive
> hdb: E295X, ATAPI CD/DVD-ROM drive
> blk: queue c02e1ee0, I/O limit 4095Mb (mask 0xffffffff)
> hdc: QUANTUM FIREBALL_TM3200A, ATA DISK drive
> blk: queue c02e2330, I/O limit 4095Mb (mask 0xffffffff)
> ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> ide1 at 0x170-0x177,0x376 on irq 15
> hda: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error }
> hda: task_no_data_intr: error=0x04 { DriveStatusError }
> hda: 6281856 sectors (3216 MB) w/76KiB Cache, CHS=779/128/63, DMA
> hdc: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error }
> hdc: task_no_data_intr: error=0x04 { DriveStatusError }
> hdc: 6281856 sectors (3216 MB) w/76KiB Cache, CHS=6232/16/63, DMA
> hdb: ATAPI 16X CD-ROM drive, 240kB Cache, DMA
> Uniform CD-ROM driver Revision: 3.12
> Partition check:
>
>
> cat /proc/ide/piix
> Controller: 0
>
> Intel PIIX4 Ultra 33 Chipset.
> --------------- Primary Channel ---------------- Secondary Channel
> -------------
> enabled enabled
> --------------- drive0 --------- drive1 -------- drive0 ----------
> drive1 ------
> DMA enabled: yes yes yes no
> UDMA enabled: no no no no
> UDMA enabled: X X X X
> UDMA
> DMA
> PIO
>
>
> hdparm -I /dev/hda
> /dev/hda:
>
> ATA device, with non-removable media
> Model Number: QUANTUM FIREBALL_TM3200A
> Serial Number: 295702034106
> Firmware Revision: A6B.2400
> Standards:
> Likely used: 2
> Configuration:
> Logical max current
> cylinders 6232 6232
> heads 16 16
> sectors/track 63 63
> --
> bytes/track: 32256 bytes/sector: 512
> CHS current addressable sectors: 6281856
> LBA user addressable sectors: 6281856
> device size with M = 1024*1024: 3067 MBytes
> device size with M = 1000*1000: 3216 MBytes (3 GB)
> Capabilities:
> LBA, IORDY(can be disabled)
> Buffer size: 76.5kB bytes avail on r/w long: 4
> Standby timer values: spec'd by Vendor
> R/W multiple sector transfer: Max = 16 Current = 16
> DMA: sdma0 sdma1 sdma2 mdma0 mdma1 *mdma2
> Cycle time: min=120ns recommended=120ns
> PIO: pio0 pio1 pio2 pio3 pio4
> Cycle time: no flow control=300ns IORDY flow control=120ns
>
> hdparm -I /dev/hdc
> /dev/hdc:
>
> ATA device, with non-removable media
> Model Number: QUANTUM FIREBALL_TM3200A
> Serial Number: 295634511413
> Firmware Revision: A6B.2400
> Standards:
> Likely used: 2
> Configuration:
> Logical max current
> cylinders 6232 6232
> heads 16 16
> sectors/track 63 63
> --
> bytes/track: 32256 bytes/sector: 512
> CHS current addressable sectors: 6281856
> LBA user addressable sectors: 6281856
> device size with M = 1024*1024: 3067 MBytes
> device size with M = 1000*1000: 3216 MBytes (3 GB)
> Capabilities:
> LBA, IORDY(can be disabled)
> Buffer size: 76.5kB bytes avail on r/w long: 4
> Standby timer values: spec'd by Vendor
> R/W multiple sector transfer: Max = 16 Current = 16
> DMA: sdma0 sdma1 sdma2 mdma0 mdma1 *mdma2
> Cycle time: min=120ns recommended=120ns
> PIO: pio0 pio1 pio2 pio3 pio4
> Cycle time: no flow control=300ns IORDY flow control=120ns
>
> Michael Frank wrote:
> > Noticed this for some time in 2.5.64 and up, and now also in 2.4.21-pre6
> > and pre7. It was OK 2.4.20. No functional problems were encountered with
> > 2.4.21, 2.5.6x so far.
> >
> > Its a P1, lspci follows
> >
> > 00:00.0 Host bridge: Intel Corp. 430HX - 82439HX TXC [Triton II] (rev 03)
> > 00:07.0 ISA bridge: Intel Corp. 82371SB PIIX3 ISA [Natoma/Triton II] (rev
> > 01) 00:07.1 IDE interface: Intel Corp. 82371SB PIIX3 IDE [Natoma/Triton
> > II] 00:09.0 VGA compatible controller: S3 Inc. ViRGE/DX or /GX (rev 01)
> > 00:0a.0 Ethernet controller: Realtek Semiconductor Co., Ltd.
> > RTL-8139/8139C/8139C+ (rev 10) 00:0b.0 SCSI storage controller: Adaptec
> > AHA-7850 (rev 01)
> >
> > Apr 10 15:17:30 mhfl1 kernel: Linux version 2.4.21-pre7-mhf18-np
> > (mhf@mhfl3) (gcc version 2.95.3 20010315 (release)) #2
> >
> > Apr 10 15:12:42 mhfl1 kernel: Uniform Multi-Platform E-IDE driver
> > Revision: 7.00beta-2.4 Apr 10 15:12:42 mhfl1 kernel: ide: Assuming 33MHz
> > system bus speed for PIO modes; override with idebus=xx Apr 10 15:12:42
> > mhfl1 kernel: PIIX3: IDE controller at PCI slot 00:07.1 Apr 10 15:12:42
> > mhfl1 kernel: PIIX3: chipset revision 0
> > Apr 10 15:12:42 mhfl1 kernel: PIIX3: not 100%% native mode: will probe
> > irqs later Apr 10 15:12:42 mhfl1 kernel: ide0: BM-DMA at
> > 0xf000-0xf007, BIOS settings: hda:pio, hdb:pio Apr 10 15:12:42 mhfl1
> > kernel: ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio,
> > hdd:pio Apr 10 15:12:42 mhfl1 kernel: hda: QUANTUM BIGFOOT2550A, ATA DISK
> > drive Apr 10 15:12:42 mhfl1 kernel: blk: queue c0347ae0, I/O limit 4095Mb
> > (mask 0xffffffff) Apr 10 15:12:42 mhfl1 kernel: ide0 at 0x1f0-0x1f7,0x3f6
> > on irq 14 Apr 10 15:12:43 mhfl1 kernel: hda: attached ide-disk driver.
> >
> > ------------------------------\/
> > Apr 10 15:12:43 mhfl1 kernel: hda: task_no_data_intr: status=0x53 {
> > DriveReady SeekComplete Index Error } Apr 10 15:12:43 mhfl1 kernel: hda:
> > task_no_data_intr: error=0x04 { DriveStatusError }
> >
> > Apr 10 15:12:43 mhfl1 kernel: hda: 5033952 sectors (2577 MB) w/87KiB
> > Cache, CHS=624/128/63, DMA Apr 10 15:12:43 mhfl1 kernel: Partition check:
> > Apr 10 15:12:43 mhfl1 kernel: hda: hda1 hda2 hda3
> >
> > ----------
> > Mar 30 15:46:51 mhfl1 kernel: Linux version 2.5.66-mhf2 (mhf@mhfl2) (gcc
> > version 2.95.3 20010315 (release)) #12 Sat Mar 29
> >
> > Mar 30 15:47:05 mhfl1 kernel: Uniform Multi-Platform E-IDE driver
> > Revision: 7.00alpha2 Mar 30 15:47:05 mhfl1 kernel: ide: Assuming 33MHz
> > system bus speed for PIO modes; override with idebus=xx Mar 30 15:47:05
> > mhfl1 kernel: PIIX3: IDE controller at PCI slot 00:07.1 Mar 30 15:47:05
> > mhfl1 kernel: PIIX3: chipset revision 0
> > Mar 30 15:47:05 mhfl1 kernel: PIIX3: not 100%% native mode: will probe
> > irqs later Mar 30 15:47:05 mhfl1 kernel: ide0: BM-DMA at
> > 0xf000-0xf007, BIOS settings: hda:pio, hdb:pio Mar 30 15:47:05 mhfl1
> > kernel: ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio,
> > hdd:pio Mar 30 15:47:05 mhfl1 kernel: hda: QUANTUM BIGFOOT2550A, ATA DISK
> > drive Mar 30 15:47:05 mhfl1 kernel: ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> >
> > ------------------------------\/
> > Mar 30 15:47:05 mhfl1 kernel: hda: task_no_data_intr: status=0x51 {
> > DriveReady SeekComplete Error } Mar 30 15:47:05 mhfl1 kernel: hda:
> > task_no_data_intr: error=0x04 { DriveStatusError }
> >
> > Mar 30 15:47:05 mhfl1 kernel: hda: 5033952 sectors (2577 MB) w/87KiB
> > Cache, CHS=4994/16/63, DMA Mar 30 15:47:05 mhfl1 kernel: hda: hda1 hda2
> > hda3
> >
> > Regards
> > Michael
> >
> > -
> > To unsubscribe from this list: send the line "unsubscribe linux-kernel"
> > in the body of a message to majordomo@vger.kernel.org
> > More majordomo info at http://vger.kernel.org/majordomo-info.html
> > Please read the FAQ at http://www.tux.org/lkml/
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/