Re: 2.4.21pre6 (__ide_dma_test_irq) called while not waiting

[Andre Hedrick]

Does the broadcom driver have a test for who owns the intq?
If it is eating the hpt370's interrupt, well you already see the picture.

Andre Hedrick
LAD Storage Consulting Group

On 9 Apr 2003, Soeren Sonnenburg wrote:

> I have a hpt370 based controller which shares an irq with a broadcom
> bcm4401 network adaptor.
> 
> when transferring stuff over the network the ide controller drops the
> dma for all disks on the controller repeatedly... so it is not a
> cable/disk problem but a problem in the nic's driver/the hpt driver.
> 
> however this stuff only happens when I put high load on the nic. the
> drives form a software raid and reconstructing it does not cause any
> trouble...
> 
> here is my setup:
> 7:   28328328          XT-PIC  ide4, ide5, eth0
> 
> 
> hdi: 4 bytes in FIFO
> hdi: timeout waiting for DMA
> hdi: (__ide_dma_test_irq) called while not waiting
> hdi: dma_intr: status=0x58 { DriveReady SeekComplete DataRequest }
> 
> hdk: dma_intr: status=0x58 { DriveReady SeekComplete DataRequest }
> 
> hdk: status timeout: status=0xd0 { Busy }
> 
> hdk: DMA disabled
> hdk: drive not ready for command
> ide4: reset: success
> ide5: reset: success
> 
> Thanks,
> Soeren.
> 
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to [e-mail]
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at  http://www.tux.org/lkml/
>