Re: Oops with usb-mass-storage

[Denis Vlasenko]

On 9 January 2003 18:50, Chrissie wrote:
> Now, i get the following output in dmesg after switching the camera
> on: hub.c: connect-debounce failed, port 2 disabled
> hub.c: new USB device 00:07.2-2, assigned address 2
> scsi1 : SCSI emulation for USB Mass Storage devices
>   Vendor:           Model:                   Rev:
>   Type:   Direct-Access                      ANSI SCSI revision: 02
> WARNING: USB Mass Storage data integrity not assured
> USB Mass Storage device found at 2
>
> Looks quite good, i think.
>
> chrissie@balearen:~$ cat /proc/scsi/scsi
> Attached devices:
> Host: scsi0 Channel: 00 Id: 00 Lun: 00
>   Vendor: LITEON   Model: CD-ROM LTN301    Rev: ML35
>   Type:   CD-ROM                           ANSI SCSI revision: 02
> Host: scsi0 Channel: 00 Id: 01 Lun: 00
>   Vendor:          Model: CD-R/RW RW7120A  Rev: 1.10
>   Type:   CD-ROM                           ANSI SCSI revision: 02
> Host: scsi1 Channel: 00 Id: 00 Lun: 00
>   Vendor: DSC      Model: Card Reader      Rev:  .
>   Type:   Direct-Access                    ANSI SCSI revision: 02
>
> The device now seems to be recogniced, and the usb-storage-to-scsi
> seems to work as well.
>
> I was very happy so far. But when i enter the following:
>
> root@balearen:~# mount /dev/sda1 /mnt -t vfat
>
> i get an kernel oops after following additional output to the console

An oops? This is *the* first oops, please decode and post it to USB folks.
Subsequent oopses are of much less help...
--
vda