ide-scsi problem in 2.5.44

[Willem Riede]

I realize Linus doesn't like ide-scsi, but while it exists I need it to work 
:-)

In 2.5.44 ide-scsi doesn't work with my OnStream DI-30 IDE Tape Drive.
Works fine with 2.4.18 on the same hardware. It's not an osst (the driver
for these devices, which I maintain) problem, the error comes from the
scsi host (ide-scsi).

When I try it, I get the following errors:

Nov  5 17:54:58 fallguy kernel: osst :I: Tape driver with OnStream support 
version 0.9.10
Nov  5 17:54:58 fallguy kernel: osst :I: $Id: osst.c,v 1.65 2001/11/11 
20:38:56 riede Exp $
Nov  5 17:54:58 fallguy kernel: osst :I: Attached OnStream SC-30 tape at 
scsi0, channel 0, id 0, lun 0 as osst0
Nov  5 17:54:58 fallguy kernel: osst :I: Attached OnStream DI-30 tape at 
scsi4, channel 0, id 1, lun 0 as osst1
Nov  5 17:55:10 fallguy kernel: osst1:W: Warning 2 (sugg. bt 0x0, driver bt 
0x0, host bt 0x0).
Nov  5 17:55:10 fallguy kernel: osst1:I: This warning may be caused by your 
scsi controller,
Nov  5 17:55:10 fallguy kernel: osst1:I: it has been reported with some 
Buslogic cards.
Nov  5 17:55:10 fallguy kernel: hdc: status error: status=0x50 { DriveReady 
SeekComplete }
Nov  5 17:55:10 fallguy kernel: ide-scsi: Strange, packet command initiated 
yet DRQ isn't asserted
Nov  5 17:55:10 fallguy kernel: osst1:W: Warning 2 (sugg. bt 0x0, driver bt 
0x0, host bt 0x0).
Nov  5 17:55:10 fallguy kernel: osst1:W: Warning 2 (sugg. bt 0x0, driver bt 
0x0, host bt 0x0).
Nov  5 17:55:10 fallguy kernel: osst1:I: Device did not become Ready in open
Nov  5 18:08:54 fallguy kernel: osst :I: Unloaded.

Note the "hdc:" and the "ide-scsi:" lines.

Does anyone know what ide-scsi's status is, and what might have gone wrong for 
me?

Thanks, Willem Riede.