After rebuilding my kernel yesterday (2.4.19-gentoo-r9) with
ACPI I ran into this same issue. I noted that at that time the
devices attached to the HPT370 were reporting at DMA 2.
I realized I'd turned the IDE cables around.
After fixing that the system worked fine. Early this morning I
decided to move the DVD drive to a different system and replaced
it with an older Samsung CD-ROM and I haven't been able to boot
since. The only change besides the CD-ROM is that my bios
setting were reset and perhaps I don't have exactly the same
settings. Alt-SysRq+b responds, and if I disable the HPT370 the
system boots without issue. I've tried disconnecting the CD-ROM
and disabling DMA at boot, none of which is working.....
I suppose I'll just go back with the HPT370 disabled and compile
a non-acpi kernel to see if it starts working again but this is baffle
the bejesus out of me.
>Dominik Geisel (dominik_at_geisel.info) Wrote:
>
>I tried 2.4.10-ac10 with your config and played around with all possible
>BIOS settings...the problem persists.
>Also, I am now quite sure it broke with BIOS version 3R.
>>On Mon, Oct 08, 2001 at 10:35:42PM +0200, Dominik Thinay wrote:
>> with kernel 2.4.11-pre3-xfs + i2c CVS-patch + lmsensors it works fine
on my
>> system (Abit Bios KT7_49B0)
>> CONFIG_PM=y
>> CONFIG_ACPI=y
>> CONFIG_ACPI_DEBUG=y
>> CONFIG_ACPI_BUSMGR=y
>> CONFIG_ACPI_SYS=y
>> CONFIG_ACPI_CPU=y
>> CONFIG_ACPI_BUTTON=y
>>
>> I remember disabled sth in the bios ...but i have forget ... :(
-- Arthur Aldridge Sun Certified Solaris Admin aj@yasashi.net- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/