Kernel 2.4.19 has run buslogic scsi just fine:
SCSI subsystem driver Revision: 1.00
PCI: Assigned IRQ 10 for device 00:08.0
scsi: ***** BusLogic SCSI Driver Version 2.1.15 of 17 August 1998 *****
scsi: Copyright 1995-1998 by Leonard N. Zubkoff <lnz@dandelion.com>
scsi0: Configuring BusLogic Model BT-958 PCI Wide Ultra SCSI Host Adapter
scsi0: Firmware Version: 5.06J, I/O Address: 0xE800, IRQ Channel: 10/Level
scsi0: PCI Bus: 0, Device: 8, Address: 0xED001000, Host Adapter SCSI ID: 7
scsi0: Parity Checking: Disabled, Extended Translation: Disabled
scsi0: Synchronous Negotiation: FFFFSFF#FFFFFFFF, Wide Negotiation: YYYYNYY#YY
YYYYYY
scsi0: Disconnect/Reconnect: Enabled, Tagged Queuing: Enabled
scsi0: Scatter/Gather Limit: 128 of 8192 segments, Mailboxes: 211
scsi0: Driver Queue Depth: 211, Host Adapter Queue Depth: 192
scsi0: Tagged Queue Depth: Automatic, Untagged Queue Depth: 3
scsi0: Error Recovery Strategy: Default, SCSI Bus Reset: Disabled
scsi0: SCSI Bus Termination: High Enabled, SCAM: Disabled
scsi0: *** BusLogic BT-958 Initialized Successfully ***
scsi0 : BusLogic BT-958
Vendor: CONNER Model: CFP2107E 2.14GB Rev: 1423
Type: Direct-Access ANSI SCSI revision: 02
Vendor: SEAGATE Model: SX423451W Rev: 9E18
Type: Direct-Access ANSI SCSI revision: 02
Vendor: TOSHIBA Model: CD-ROM XM-5701TA Rev: 0167
Type: CD-ROM ANSI SCSI revision: 02
scsi0: Target 0: Queue Depth 28, Wide Synchronous at 20.0 MB/sec, offset 15
scsi0: Target 1: Queue Depth 28, Wide Synchronous at 20.0 MB/sec, offset 15
scsi0: Target 2: Queue Depth 3, Synchronous at 10.0 MB/sec, offset 8
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
Attached scsi disk sdb at scsi0, channel 0, id 1, lun 0
SCSI device sda: 4194303 512-byte hdwr sectors (2147 MB)
sda: sda1 sda2
SCSI device sdb: 45322644 512-byte hdwr sectors (23205 MB)
sdb: sdb1 sdb2 sdb3
-----------------------------
Kernel 2.5.43 and earlier produce this dmesg info
(edited redundant lines):
SCSI subsystem driver Revision: 1.00
PCI: Assigned IRQ 10 for device 00:08.0
scsi: ***** BusLogic SCSI Driver Version 2.1.16 of 18 July 2002 *****
scsi: Copyright 1995-1998 by Leonard N. Zubkoff <lnz@dandelion.com>
scsi0: Configuring BusLogic Model BT-958 PCI Wide Ultra SCSI Host Adapter
scsi0: Firmware Version: 5.06J, I/O Address: 0xE800, IRQ Channel: 10/Level
scsi0: PCI Bus: 0, Device: 8, Address: 0xED001000, Host Adapter SCSI ID: 7
scsi0: Parity Checking: Disabled, Extended Translation: Disabled
scsi0: Synchronous Negotiation: FFFFSFF#FFFFFFFF, Wide Negotiation: YYYYNYY#YY
YYYYYY
scsi0: Disconnect/Reconnect: Enabled, Tagged Queuing: Enabled
scsi0: Scatter/Gather Limit: 128 of 8192 segments, Mailboxes: 211
scsi0: Driver Queue Depth: 211, Host Adapter Queue Depth: 192
scsi0: Tagged Queue Depth: Automatic, Untagged Queue Depth: 3
scsi0: Error Recovery Strategy: Default, SCSI Bus Reset: Disabled
scsi0: SCSI Bus Termination: High Enabled, SCAM: Disabled
scsi0: *** BusLogic BT-958 Initialized Successfully ***
scsi0 : BusLogic BT-958
Vendor: CONNER Model: CFP2107E 2.14GB Rev: 1423
Type: Direct-Access ANSI SCSI revision: 02
Vendor: SEAGATE Model: SX423451W Rev: 9E18
Type: Direct-Access ANSI SCSI revision: 02
scsi_eh_offline_sdevs: Device offlined - not ready or command retry failed after
error recovery: host 0 channel 0 id 1 lun 0
scsi_eh_offline_sdevs: Device offlined - not ready or command retry failed after
error recovery: host 0 channel 0 id 1 lun 0
scsi_eh_offline_sdevs: Device offlined - not ready or command retry failed after
error recovery: host 0 channel 0 id 2 lun 0
Vendor: Model: Rev:
Type: Direct-Access ANSI SCSI revision: 00
scsi_eh_offline_sdevs: Device offlined - not ready or command retry failed after
error recovery: host 0 channel 0 id 2 lun 0
scsi_eh_offline_sdevs: Device offlined - not ready or command retry failed after
error recovery: host 0 channel 0 id 2 lun 0
scsi_eh_offline_sdevs: Device offlined - not ready or command retry failed after
error recovery: host 0 channel 0 id 3 lun 0
Vendor: Model: Rev:
Type: Direct-Access ANSI SCSI revision: 00
.
.
.
scsi_eh_offline_sdevs: Device offlined - not ready or command retry failed after
error recovery: host 0 channel 0 id 15 lun 0
Vendor: Model: Rev:
Type: Direct-Access ANSI SCSI revision: 00
scsi_eh_offline_sdevs: Device offlined - not ready or command retry failed after
error recovery: host 0 channel 0 id 15 lun 0
scsi_eh_offline_sdevs: Device offlined - not ready or command retry failed after
error recovery: host 0 channel 0 id 15 lun 0
st: Version 20021015, fixed bufsize 32768, wrt 30720, s/g segs 256
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
Attached scsi disk sdb at scsi0, channel 0, id 1, lun 0
Attached scsi disk sdc at scsi0, channel 0, id 2, lun 0
Attached scsi disk sdd at scsi0, channel 0, id 3, lun 0
Attached scsi disk sde at scsi0, channel 0, id 4, lun 0
Attached scsi disk sdf at scsi0, channel 0, id 5, lun 0
Attached scsi disk sdg at scsi0, channel 0, id 6, lun 0
Attached scsi disk sdh at scsi0, channel 0, id 8, lun 0
Attached scsi disk sdi at scsi0, channel 0, id 9, lun 0
Attached scsi disk sdj at scsi0, channel 0, id 10, lun 0
Attached scsi disk sdk at scsi0, channel 0, id 11, lun 0
Attached scsi disk sdl at scsi0, channel 0, id 12, lun 0
Attached scsi disk sdm at scsi0, channel 0, id 13, lun 0
Attached scsi disk sdn at scsi0, channel 0, id 14, lun 0
Attached scsi disk sdo at scsi0, channel 0, id 15, lun 0
scsi_eh_offline_sdevs: Device offlined - not ready or command retry failed after
error recovery: host 0 channel 0 id 0 lun 0
scsi_eh_offline_sdevs: Device offlined - not ready or command retry failed after
error recovery: host 0 channel 0 id 0 lun 0
SCSI device sda: drive cache: write through
scsi_eh_offline_sdevs: Device offlined - not ready or command retry failed after
error recovery: host 0 channel 0 id 0 lun 0
sda : sector size 0 reported, assuming 512.
SCSI device sda: 1 512-byte hdwr sectors (0 MB)
.
.
.
scsi_eh_offline_sdevs: Device offlined - not ready or command retry failed after
error recovery: host 0 channel 0 id 15 lun 0
scsi_eh_offline_sdevs: Device offlined - not ready or command retry failed after
error recovery: host 0 channel 0 id 15 lun 0
SCSI device sdo: drive cache: write through
scsi_eh_offline_sdevs: Device offlined - not ready or command retry failed after
error recovery: host 0 channel 0 id 15 lun 0
sdo : sector size 0 reported, assuming 512.
SCSI device sdo: 1 512-byte hdwr sectors (0 MB)
Initializing USB Mass Storage driver...
--
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/