tg3 and Netgear GA302T x 2 locks machine

Ben Greear (greearb@candelatech.com)
Thu, 03 Oct 2002 21:19:37 -0700


Got my two new Netgear GA302t nics today. They seem to use the
tg3 driver....

I put them into the 64/66 slots on my Tyan dual amd motherboard..
Running kernel 2.4.20-pre8

eth2 is plugged into eth3 over cross-over cable.

The tg3 found and used them, mostly:

tg3.c:v1.1 (Aug 30, 2002)
eth2: Tigon3 [partno(AC91002A1) rev 0105 PHY(5701)] (PCI:66MHz:32-bit) 10/100/1000BaseT Ethernet 00:40:f4:47:20:56
eth3: Tigon3 [partno(AC91002A1) rev 0105 PHY(5701)] (PCI:66MHz:32-bit) 10/100/1000BaseT Ethernet 00:40:f4:47:22:fd
tg3: eth3: Link is up at 1000 Mbps, full duplex.
tg3: eth3: Flow control is off for TX and off for RX.
...
tg3: eth3: Link is up at 1000 Mbps, full duplex.
tg3: eth3: Flow control is off for TX and off for RX.
tg3: eth3: Link is down.
tg3: eth3: Link is up at 1000 Mbps, full duplex.
tg3: eth3: Flow control is on for TX and on for RX.

I tried to start traffic with pktgen, and the machine hangs solid.
The last thing I see is:

[root@localhost root]# tg3: eth2: transmit timed out, resetting

Any ideas? Is this NIC supposed to work with tg3?

Thanks,
Ben

-- 
Ben Greear <greearb@candelatech.com>       <Ben_Greear AT excite.com>
President of Candela Technologies Inc      http://www.candelatech.com
ScryMUD:  http://scry.wanfear.com     http://scry.wanfear.com/~greear

- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/