ServerWorks^® Grand Champion LE North Bridge (CMIC-LE)
ServerWorks^® Champion South Bridge (CSB5)
ServerWorks^® 64-bit PCI-X Bridge (CIOB-X2)
And the Serverworks IDE driver doesn't see my drive.
Works Fine with 2.4.20-pre8
Who should I be talking to?
JF wrote:
>On Sun, 2002-09-29 at 23:50, Andrew Walrond wrote:
>
>
>>Hi,
>>
>>I can't boot with 2.5.39 because the built-in ide driver (ServerWorks
>>CSB5) can't see hda, and VFS says "Cannot open root device "hda3" or
>>03:03" which results in a kernel panic
>>
>>Works fine with 2.4.20-pre? with identical kernel setup and kernel
>>parameter root=/dev/hda3
>>
>>Is this a known problem? Any way around it or patches?
>>
>>
>
>I used to have this problem with 2.5 too
>It went from the IDE controller chipset.
>
>Are you sure that you have only 1 IDE controller chipset ?
>
>I have both PIIX4 and HPT366. Root FS is on HPT366 controller. Enabling
>only PIIX4 used to work with 2.4 but doesn't with 2.5 anymore (got
>exactly your problem). I had to enable specific support for both.
>
>I suppose your root FS is on a specific IDE controller for which the
>support is not enabled (check the different type in the IDE/ATA kernel
>config section)
>
>Regards.
>
>
>
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/