Hmm, works fine here so far, though I only have tested the parallel
port in polling mode (that's how it is set up by default).
> 00:0e.0 Communication controller: NetMos Technology 222N-2 I/O Card (2S+1P) (rev 01)
Mine is "ST Lab PCI 2S1P IO Controller Card" - which has no serial
configuration EEPROM (there is an empty place for it on the PCB).
The 9710:9835 numbers are the generic defaults hardwired in the
NM9835 chip, not specific to any board type like "222N-2".
> I have been using this setup for a while now.
I haven't heard anything from the kernel people yet - any chances of
getting these changes into the official 2.4.x source? I can make
a second patch (NetMos support) after the first one is accepted...
Marek
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/