Re: kernel panic while cd writing

[Markus Plail]

Hi Justyna!

* Justyna Biała writes:
>Hi.

>I have LiteOn 40x12x48x cd-writer, linux 2.4.19, cdrecord 1.11a24,
>Duron 1000 MHz, ECS K7S5A with SIS735 chipset. My cd-writer works fine
>only in two cases: 

I also have a ECS K7S5A, but I have an acer 2010A cd-writer.

>1. when the speed is not higher than 12x (no matter if the dma is on)
>2. with speed = 32x but only when I turn the dma off with hdparm

My problem was, that the system load was almost unbearable at higher
speeds, but only when I was burning DAO. Do you burn DAO? Is your
system load (top) also very high?
Now I just upgraded to 2.4.20-pre3 and everything is just fine :-) I am
not really sure if it was only the kernel, because I still have the
same problem when I tell the kernel to umask the drive's IRQ (hdparm -u1).
I am not 100% sure if I tried it without umask before.
But without umask, everything seems to work fine now. There's just a
few percent CPU load when doing c2scan or writing DAO.
The only thing is that if I do a c2scan under X, X consumes all my CPU
time after some time and gets unresponsive. Doing the same in the
console there's no problem at all. So I am pretty sure this is a X
problem and not the kernel's.

regards
Markus