Re: Tyan K7X with AMD MP 2.4.19-rc3-ac4

Thomas (thomas@mierau.org)
Wed, 31 Jul 2002 23:41:26 +0200


Thank's Rudmer

Actually it is disabbled intentionally. The eth0 will install itself on
the IRQ11 and I didn't find a way to get it somewhere else. IRQ11 is
used by the SCSI Raid Controller already whic is fixed in the 66Mhz
64Bit slot(and later on by another onbord AIC7xxx device which I am also
unable to reroute up to now)
And even the eth1 is not working properly

Rudmer van Dijk wrote:

> At 14:21 30-7-02, Thomas Mierau wrote:
>
>> Hi
>>
>> I am trying to get the above board to work. Somehow it doesn't.
>> I tried kernel 2.4.18, 2.4.19-rc3, 2.4.19-rc3-ac3 and of course the
>> latest
>> 2.4.19-rc3-ac4
>>
>> The machine itself is "working" stable under 2.4.18 with a limited
>> functionality (no network, no additional scsi ports, no printer, no
>> usb ...)
>>
>> The problem is always the same. The eth1 is not working properly and
>> the IRQ's
>> are not setup correctly. The I/O-APIC reports ok.
>
>
> i don't know about the IRQ's but the second nic can be enabled by
> entering 'ether=0,0,eth1' at the kernel commandline. see also the file
> for your networkcard in Documentation/networking or see section 2.3 of
> the Ethernet HOWTO.
>
> Rudmer
>
>
>

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/