I'm getting the below errors when plugging in a maxtor 160 as of
2.4.19-rc3-ac3 + the next couple of csets after v2.4.19-rc3.
They did not show up in 2.4.19-pre8 and earlier.
I've not yet tested the svn tree.
After the errors are some relevant data about the drive.
As you can see from them and the fdisk -l -u output, the error sectors
are well beyond the partition table's idea of the end of the disk, but
I see the previous kernels also saw 320173056 sectors; they just
didn't give the lba oor errors.
Anyone have any thoughts on this?
--=-=-=
Content-Disposition: inline
kernel: ohci1394_0: SelfID received outside of bus reset sequence
kernel: ieee1394: Device added: Node[01:1023] GUID[0010b90101409990] [Maxtor ]
kernel: ieee1394: sbp2: Logged into SBP-2 device
kernel: ieee1394: sbp2: Node[01:1023]: Max speed [S400] - Max payload [2048]
kernel: scsi0 : IEEE-1394 SBP-2 protocol driver (host: ohci1394)
kernel: $Rev: 515 $ James Goodwin <jamesg@filanet.com>
kernel: SBP-2 module load options:
kernel: - Max speed supported: S400
kernel: - Max sectors per I/O supported: 255
kernel: - Max outstanding commands supported: 8
kernel: - Max outstanding commands per lun supported: 1
kernel: - Serialized I/O (debug): no
kernel: - Exclusive login: yes
kernel: Vendor: Maxtor Model: 1394 storage Rev: v1.2
kernel: Type: Direct-Access ANSI SCSI revision: 06
kernel: Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
kernel: SCSI device sda: 320173056 512-byte hdwr sectors (163929 MB)
kernel: sda:SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173048
kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173049
kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173050
kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173051
kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173052
kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173053
kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173054
kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173055
kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173048
kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173049
kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173050
kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173051
kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173052
kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173053
kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173054
kernel: SCSI disk error : host 0 channel 0 id 0 lun 0 return code = 8000002
kernel: Current sd08:00: sense key Aborted Command
kernel: Additional sense indicates Logical block address out of range
kernel: I/O error: dev 08:00, sector 320173055
kernel: sda1 sda2
insmod: Using /lib/modules/2.4.19-rc3-ac3+/kernel/drivers/ieee1394/sbp2.o
insmod: Symbol version prefix ''
--=-=-=
Content-Disposition: inline
:; fdisk -l -u /dev/sda
Disk /dev/sda: 255 heads, 63 sectors, 19929 cylinders
Units = sectors of 1 * 512 bytes
Device Boot Start End Blocks Id System
/dev/sda1 63 80051894 40025916 c Win95 FAT32 (LBA)
/dev/sda2 80051895 320159384 120053745 83 Linux
--=-=-=
Content-Disposition: inline
:; cat /proc/bus/ieee1394/devices
Node[00:1023] GUID[424fc0002de51021]:
Vendor ID: `Linux OHCI-1394' [0x000000]
Capabilities: 0x0083c0
Bus Options:
IRMC(1) CMC(1) ISC(1) BMC(0) PMC(0) GEN(0)
LSPD(2) MAX_REC(2048) CYC_CLK_ACC(0)
Host Node Status:
Host Driver : ohci1394
Nodes connected : 2
Nodes active : 2
SelfIDs received: 2
Irm ID : [00:1023]
BusMgr ID : [00:1023]
In Bus Reset : no
Root : no
Cycle Master : no
IRM : yes
Bus Manager : yes
Node[01:1023] GUID[0010b90101409990]:
Vendor ID: `Maxtor ' [0x0010b9]
Capabilities: 0x0083c0
Bus Options:
IRMC(0) CMC(0) ISC(0) BMC(0) PMC(0) GEN(0)
LSPD(0) MAX_REC(64) CYC_CLK_ACC(255)
Unit Directory 0:
Vendor/Model ID: Maxtor [0010b9] / 1394 storage [000001]
Software Specifier ID: 00609e
Software Version: 010483
Driver: SBP2 Driver
Length (in quads): 8
--=-=-=--
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/