diff -u --new-file --recursive --exclude-from /usr/src/exclude linux-2.5.27/include/linux/i2o.h linux-2.5.27-ac1/include/linux/i2o.h
--- linux-2.5.27/include/linux/i2o.h Sat Jul 20 20:11:11 2002
+++ linux-2.5.27-ac1/include/linux/i2o.h Sun Jul 21 15:20:20 2002
@@ -81,9 +81,9 @@
struct i2o_pci
{
int irq;
- int queue_buggy:3; /* Don't send a lot of messages */
int short_req:1; /* Use small block sizes */
int dpt:1; /* Don't quiesce */
+ int promise:1; /* Promise controller */
#ifdef CONFIG_MTRR
int mtrr_reg0;
int mtrr_reg1;
@@ -112,9 +112,9 @@
atomic_t users;
struct i2o_device *devices; /* I2O device chain */
struct i2o_controller *next; /* Controller chain */
- volatile u32 *post_port; /* Inbout port */
- volatile u32 *reply_port; /* Outbound port */
- volatile u32 *irq_mask; /* Interrupt register */
+ unsigned long post_port; /* Inbout port address */
+ unsigned long reply_port; /* Outbound port address */
+ unsigned long irq_mask; /* Interrupt register address */
/* Dynamic LCT related data */
struct semaphore lct_sem;
@@ -122,12 +122,17 @@
int lct_running;
i2o_status_block *status_block; /* IOP status block */
+ dma_addr_t status_block_phys;
i2o_lct *lct; /* Logical Config Table */
+ dma_addr_t lct_phys;
i2o_lct *dlct; /* Temp LCT */
+ dma_addr_t dlct_phys;
i2o_hrt *hrt; /* HW Resource Table */
+ dma_addr_t hrt_phys;
+ u32 hrt_len;
- u32 mem_offset; /* MFA offset */
- u32 mem_phys; /* MFA physical */
+ unsigned long mem_offset; /* MFA offset */
+ unsigned long mem_phys; /* MFA physical */
int battery:1; /* Has a battery backup */
int io_alloc:1; /* An I/O resource was allocated */
@@ -252,34 +257,34 @@
*/
static inline u32 I2O_POST_READ32(struct i2o_controller *c)
{
- return *c->post_port;
+ return readl(c->post_port);
}
-static inline void I2O_POST_WRITE32(struct i2o_controller *c, u32 Val)
+static inline void I2O_POST_WRITE32(struct i2o_controller *c, u32 val)
{
- *c->post_port = Val;
+ writel(val, c->post_port);
}
static inline u32 I2O_REPLY_READ32(struct i2o_controller *c)
{
- return *c->reply_port;
+ return readl(c->reply_port);
}
-static inline void I2O_REPLY_WRITE32(struct i2o_controller *c, u32 Val)
+static inline void I2O_REPLY_WRITE32(struct i2o_controller *c, u32 val)
{
- *c->reply_port = Val;
+ writel(val, c->reply_port);
}
static inline u32 I2O_IRQ_READ32(struct i2o_controller *c)
{
- return *c->irq_mask;
+ return readl(c->irq_mask);
}
-static inline void I2O_IRQ_WRITE32(struct i2o_controller *c, u32 Val)
+static inline void I2O_IRQ_WRITE32(struct i2o_controller *c, u32 val)
{
- *c->irq_mask = Val;
+ writel(val, c->irq_mask);
}
@@ -295,6 +300,13 @@
I2O_REPLY_WRITE32(c, m);
}
+/*
+ * Endian handling wrapped into the macro - keeps the core code
+ * cleaner.
+ */
+
+#define i2o_raw_writel(val, mem) __raw_writel(cpu_to_le32(val), mem)
+
extern struct i2o_controller *i2o_find_controller(int);
extern void i2o_unlock_controller(struct i2o_controller *);
extern struct i2o_controller *i2o_controller_chain;
@@ -313,7 +325,7 @@
extern int i2o_post_this(struct i2o_controller *, u32 *, int);
extern int i2o_post_wait(struct i2o_controller *, u32 *, int, int);
extern int i2o_post_wait_mem(struct i2o_controller *, u32 *, int, int,
- void *, void *);
+ void *, void *, dma_addr_t, dma_addr_t, int, int);
extern int i2o_query_scalar(struct i2o_controller *, int, int, int, void *,
int);
@@ -339,13 +351,66 @@
extern void i2o_run_queue(struct i2o_controller *);
extern int i2o_delete_controller(struct i2o_controller *);
+/*
+ * Cache strategies
+ */
+
+
+/* The NULL strategy leaves everything up to the controller. This tends to be a
+ * pessimal but functional choice.
+ */
+#define CACHE_NULL 0
+/* Prefetch data when reading. We continually attempt to load the next 32 sectors
+ * into the controller cache.
+ */
+#define CACHE_PREFETCH 1
+/* Prefetch data when reading. We sometimes attempt to load the next 32 sectors
+ * into the controller cache. When an I/O is less <= 8K we assume its probably
+ * not sequential and don't prefetch (default)
+ */
+#define CACHE_SMARTFETCH 2
+/* Data is written to the cache and then out on to the disk. The I/O must be
+ * physically on the medium before the write is acknowledged (default without
+ * NVRAM)
+ */
+#define CACHE_WRITETHROUGH 17
+/* Data is written to the cache and then out on to the disk. The controller
+ * is permitted to write back the cache any way it wants. (default if battery
+ * backed NVRAM is present). It can be useful to set this for swap regardless of
+ * battery state.
+ */
+#define CACHE_WRITEBACK 18
+/* Optimise for under powered controllers, especially on RAID1 and RAID0. We
+ * write large I/O's directly to disk bypassing the cache to avoid the extra
+ * memory copy hits. Small writes are writeback cached
+ */
+#define CACHE_SMARTBACK 19
+/* Optimise for under powered controllers, especially on RAID1 and RAID0. We
+ * write large I/O's directly to disk bypassing the cache to avoid the extra
+ * memory copy hits. Small writes are writethrough cached. Suitable for devices
+ * lacking battery backup
+ */
+#define CACHE_SMARTTHROUGH 20
+
+/*
+ * Ioctl structures
+ */
+
+
+#define BLKI2OGRSTRAT _IOR('2', 1, int)
+#define BLKI2OGWSTRAT _IOR('2', 2, int)
+#define BLKI2OSRSTRAT _IOW('2', 3, int)
+#define BLKI2OSWSTRAT _IOW('2', 4, int)
+
+
+
/*
- * I2O Function codes
+ * I2O Function codes
*/
/*
- * Executive Class
+ * Executive Class
*/
#define I2O_CMD_ADAPTER_ASSIGN 0xB3
#define I2O_CMD_ADAPTER_READ 0xB2
@@ -416,6 +481,7 @@
#define I2O_CMD_BLOCK_MUNLOCK 0x4B
#define I2O_CMD_BLOCK_MMOUNT 0x41
#define I2O_CMD_BLOCK_MEJECT 0x43
+#define I2O_CMD_BLOCK_POWER 0x70
#define I2O_PRIVATE_MSG 0xFF
@@ -574,6 +640,7 @@
#define EIGHT_WORD_MSG_SIZE 0x00080000
#define NINE_WORD_MSG_SIZE 0x00090000
#define TEN_WORD_MSG_SIZE 0x000A0000
+#define ELEVEN_WORD_MSG_SIZE 0x000B0000
#define I2O_MESSAGE_SIZE(x) ((x)<<16)
@@ -582,10 +649,10 @@
#define ADAPTER_TID 0
#define HOST_TID 1
-#define MSG_FRAME_SIZE 128
+#define MSG_FRAME_SIZE 64 /* i2o_scsi assumes >= 32 */
#define NMBR_MSG_FRAMES 128
-#define MSG_POOL_SIZE 16384
+#define MSG_POOL_SIZE (MSG_FRAME_SIZE*NMBR_MSG_FRAMES*sizeof(u32))
#define I2O_POST_WAIT_OK 0
#define I2O_POST_WAIT_TIMEOUT -ETIMEDOUT
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/