RE: [Lse-tech] RE: ext3 performance bottleneck as the number of s

[Gross, Mark]

We are running the tests with the following mother board.
http://www.intel.com/design/servers/scb2/index.htm?iid=ipp_browse+motherbd_s
cb2&

Its a very nice box with 2 independent 64/66 PCI buses.  
Capable of 2x503MB/sec, using your logic ;)

Regardless, the 640MB/s number was computed without considering the PCI bus
limitations, or the dual port nature of the base 160MB/sec nature of the
Adabptec SCSI-39160.
http://www.adaptec.com/worldwide/product/proddetail.html?sess=no&prodkey=ASC
-39160&cat=Products

Realistically, we are looking for a max throughput of about 320MB/sec with 4
adapters with enough drives attached.

--mgross

(W) 503-712-8218
MS: JF1-05
2111 N.E. 25th Ave.
Hillsboro, OR 97124

> -----Original Message-----
> From: Christopher E. Brown [mailto:[e-mail]]
> Sent: Saturday, June 22, 2002 9:03 PM
> To: Griffiths, Richard A
> Cc: 'Andrew Morton'; [e-mail]; 'Jens Axboe'; Linux
> Kernel Mailing List; [e-mail]
> Subject: [Lse-tech] RE: ext3 performance bottleneck as the number of
> spindles gets large
> 
> 
> On Thu, 20 Jun 2002, Griffiths, Richard A wrote:
> 
> > I should have mentioned the throughput we saw on 4 adapters 
> 6 drives was
> > 126KB/s.  The max theoretical bus bandwith is 640MB/s.
> 
> 
> This is *NOT* correct.  Assuming a 64bit 66Mhz PCI bus your MAX is
> 503MB/sec minus PCI overhead...
> 
> This of course assumes nothing else is using the PCI bus.
> 
> 
> 120 something MB/sec sounds a hell of a lot like topping out a 32bit
> 33Mhz PCI bus, but IIRC the earlier posting listed 39160 cards, PCI
> 64bit w/ backward compat to 32bit.
> 
> You do have *ALL* of these cards plugged into a full PCI 64bit/66Mhz
> slot right?  Not plugging them into a 32bit/33Mhz slot?
> 
> 
> 32bit/33Mhz	(32 * 33,000,000) / (1024 * 1024 * 8) = 125.89 MByte/sec
> 64bit/33Mhz	(64 * 33,000,000) / (1024 * 1024 * 8) = 251.77 MByte/sec
> 64bit/66Mhz	(64 * 66,000,000) / (1024 * 1024 * 8) = 503.54 MByte/sec
> 
> 
> NOTE: PCI transfer rates are often listed as
> 
> 32bit/33Mhz, 132 MByte/sec
> 64bit/33Mhz, 264 MByte/sec
> 64bit/66Mhz, 528 MByte/sec
> 
> This is somewhat true, but only if we start with Mbit rates as used in
> transmission rates (1,000,000 bits/sec) and work from there, instead
> of 2^20 (1,048,576).  I will not argue about PCI 32bit/33Mhz being
> 1056Mbit, if talking about line rate, but when we are talking about
> storage media and transfers to/from as measured by files remember to
> convert.
> 
> -- 
> I route, therefore you are.
> 
> 
> 
> 
> -------------------------------------------------------
> Sponsored by:
> ThinkGeek at http://www.ThinkGeek.com/
> _______________________________________________
> Lse-tech mailing list
> [e-mail]
> https://lists.sourceforge.net/lists/listinfo/lse-tech
>