3c59x driver: card not responding after a while

[Ronny T. Lampert]

Hello,

I'm having (reproducable) problems with the 3c59x driver; after a while
(depends on card/traffic), the card doesn't send nor receive anymore.

I had 3c905B and 3c905C series, both affected. I did also change
mainboard-slots.
My current card is identifying as:
00:0c.0 Ethernet controller: 3Com Corporation 3c905C-TX [Fast Etherlink]
(rev 74)
        Subsystem: 3Com Corporation 3C905C-TX Fast Etherlink for PC
Management NIC
        Flags: bus master, medium devsel, latency 64, IRQ 11
        I/O ports at e800 [size=128]
        Memory at ed000000 (32-bit, non-prefetchable) [size=128]
        Expansion ROM at ec000000 [disabled] [size=128K]
        Capabilities: [dc] Power Management version 2

Kernels were
o RH 7.2 stock (2.4.7)
o 2.4.17 (custom, driver builtin) (after a while)
o 2.4.18 (custom, driver builtin) (depending on traffic, last time:
[ifconfig output after the device is frozen]
          RX packets:249782 errors:0 dropped:0 overruns:94 frame:0
          TX packets:32712 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100 
          RX bytes:49988234 (47.6 Mb)  TX bytes:8716361 (8.3 Mb)

2.2.19 worked fine.
gcc -v is gcc version 2.96 20000731 (Red Hat Linux 7.1 2.96-98) (std
from RH 7.2; no 'kgcc' available)
I saw no changes in 2.4.19*, so I went out asking you :)

Machine is a K6-2 500 via a VIA MVP3 chipset, Shuttle mainboard (if that
matters).

If you do a /etc/init.d/network restart (or ifconfig eth0 down ;
ifconfig eth0 ... up), the card works again.
dmesg is not reporting anything.
I also did force the card to using fixed 100BaseTx-FD, didn't change
anything.

If you need further information or more testing please say so.
Please also include me on CC.
Thanks.
-- 
Ronny T. Lampert		email: [e-mail]
System Administrator		voice: [phone]
Ericsson Eurolab Deutschland	fax:   [phone]
Nuernberg, Germany