Certainly in 2.4.18 (and I've seen a pile of other similar reports).
> If I remember properly my debug session with Alan (that was a
> long while ago), the COR reset was screwing up the firmware (well, how
> many time did I told you to not make it mandatory ?).
Long time ago -its been behaving well until fairly recently
> Alan has an old Compaq card (the Intersil PrismII variety, not
> the new Lucent one) and his firmware is probably not very fresh.
Oldish firmware definitely. The newer driver finds the card registers
it but fails on all tx/rx and reports no signal and noise of
130/150 or so (as opposed to db). Flipping back to the older kernel it
works happily.
Any specific info/debug/traces that would help ?
Alan
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/