Re: HPT372 on KR7A-133R (ATA133) on production server

[Vasja J Zupan]

Ok,
I see, what CPU do you use? I'm planning to go for Athlon XP 1800+.
I do not see my services would use 100% CPU at any time but I cannot be 100%
certain!
I'll add 512MB DDR PC266 RAM (vendor unknown at this time).

I also plan to add raiserfs for two mirror 40GB WD ata100 7200rpm.

Any suggestions?

rgds,
Vasja

----- Original Message -----
From: "Etienne Lorrain" <[e-mail]>
To: <[e-mail]>
Cc: <[e-mail]>
Sent: Thursday, April 18, 2002 5:59 PM
Subject: Re: HPT372 on KR7A-133R (ATA133) on production server

>   I have this exact motherboard, with CRUCIAL 256MB 184DIMM PC2100 NP
CL2.5
>  memory.
>  You first have to patch your kernel like Andy Jeffries said to activate
>  the RAID controller. Most of the distribution still did not do it,
>  you probably have to compile your own kernel.
>
>  For a long time, I have only been able to run it 100% CPU for one hour,
>  no disk access, if I set the memory clock to 100/200 MHZ.
>
>  I am currently experimenting running at 133/266 MHz with the two
>  parameters "DDR DQS Input Delay" and "DDR DQS Output Delay" changed
>  to manual and increased by 2.
>  Their autodetection does not seem to work, I am not sure.
>  It seems stable - no error noticed for the last few weeks.
>  Note that 100/200 to 133/266 did not seem to increase the CPU speed
>  a lot, my usual task takes 39 minutes 100% CPU in 133/266 and
>  40 min in 100/200 mode.
>  I am not on a production server, so your millage may vary.
>
>   Just my ?0.02,
>   Etienne.
>
> ___________________________________________________________
> Do You Yahoo!? -- Une adresse @yahoo.fr gratuite et en français !
> Yahoo! Mail : http://fr.mail.yahoo.com
>