tg3.c:v0.97 (Mar 13, 2002)
eth2: Tigon3 [partno(BCM95700A6) rev 7102 PHY(5401)] (PCI:33MHz:64-bit)
10/100/1000BaseT Ethernet 00:04:76:2f:c2:b0
eth2: Link is up at 1000 Mbps, full duplex.
eth2: Flow control is off for TX and off for RX.
05:03.0 Ethernet controller: BROADCOM Corporation NetXtreme BCM5700
Gigabit Ethernet (rev 12)
Subsystem: 3Com Corporation 3C996-T 1000BaseTX
Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 22
Memory at fd300000 (64-bit, non-prefetchable) [size=64K]
Capabilities: [40] #07 [0000]
Capabilities: [48] Power Management version 2
Capabilities: [50] Vital Product Data
Capabilities: [58] Message Signalled Interrupts: 64bit+ Queue=0/3
Enable-
Seems to work.. but I guess I shouldn't say anything yet because uptime is
only 20 minutes so far :)
We'll see.
How about vlans.. should it say something about enabling hardware vlan
tagging when I configure some vlans?
- Pasi Kärkkäinen
^
. .
Linux
/ - \
Choice.of.the
.Next.Generation.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/