Here are the new boot messages:
Regards. Paul
Kernel command line: auto BOOT_IMAGE=2.4.17.9 ro root=301 BOOT_FILE=/boot/bzImage-2.4.17.9 idebus=66 ide0=ata66 pci=biosirq
ide_setup: idebus=66
ide_setup: ide0=ata66
PCI: PCI BIOS revision 2.10 entry at 0xf1170, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 0: assuming transparent
PCI: Using IRQ router ALI [10b9/1533] at 00:07.0
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 66MHz system bus speed for PIO modes
ALI15X3: IDE controller on PCI bus 00 dev 20
PCI: No IRQ known for interrupt pin A of device 00:04.0.
ALI15X3: chipset revision 196
ALI15X3: not 100% native mode: will probe irqs later
ALI15X3: ATA-66/100 forced bit set (WARNING)!!
ide0: BM-DMA at 0xd400-0xd407, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xd408-0xd40f, BIOS settings: hdc:pio, hdd:DMA
hda: IC35L040AVER07-0, ATA DISK drive
hdb: CDU5211, ATAPI CD/DVD-ROM drive
hdd: IOMEGA ZIP 250 ATAPI, ATAPI FLOPPY drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 80418240 sectors (41174 MB) w/1916KiB Cache, CHS=5005/255/63
hdb: ATAPI 52X CD-ROM drive, 120kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
Partition check:
hda: hda1 hda2
On Sun, Feb 10, 2002 at 06:17:56PM -0500, Mark Hahn wrote:
> > PCI: No IRQ known for interrupt pin A of device 00:04.0.
>
> are you sure you don't have the bios set for "PNP OS"?
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/