Not to say that the HPs smell like roses, but I would highly suspect bad
hardware or a suspect BIOS/PCB revision, etc. in this case.
Just my US$0.02,
-- Ken. brownfld@irridi.com* besides a quirky arp issue on boot that seemed to go away on its own and wasn't card-specific. And the long-standing I/O APIC issues. ;)
On Fri, Feb 01, 2002 at 01:16:15PM -0500, nick@snowman.net wrote: | Odd, I've got an HP LPr with an Ethernet controller: Intel Corporation | 82557 [Ethernet Pro 100] (rev 8). on the riser. Works fine for me under | the debian SMP kernel Linux version 2.4.5-686-smp (herbert@gondolin) (gcc | version 2.95.4 20010319 (Debian prerelease)) #1 SMP Sun May 27 18:32:54 | EST 2001. If you'd like me to test a workload or similar let me know, the | system is relativly low memory though. | Nick | | On 1 Feb 2002, Edward S. Marshall wrote: | | > On Thu, 2002-01-31 at 11:54, Ben Greear wrote: | > > The only lockup problems I have run into are connecting some eepro nics to | > > a 10bt hub, and using (cheap arsed, it appears) PCI riser cards. I have | > > heard of some SMP related issues, but nothing concrete, and I don't | > > have any SMP systems personally. You could try the e100, but I have | > > no idea if it will be better or worse for your particular problem. | > | > I was running into the same problems here; SMP system w/PCI riser card | > (HP NetServer LPr), connected to a 10/100 switch. I'd get | > "wait_for_command_timeout" errors all the time under moderate network | > load. Switching to the e100 driver didn't help in the slightest. | > Eventually, I'd experience a complete system lockup. | > | > Replacing the card with a 3c59x-based card put the machine back in | > service (I've completely written eepro100s off as a viable cards now), | > although I still saw occasional PCI-related issues. Specifically: | > | > Jan 23 10:11:37 x kernel: Uhhuh. NMI received. Dazed and confused, but | > trying to continue | > Jan 23 10:11:37 x kernel: eth0: Host error, FIFO diagnostic register | > 0000. | > Jan 23 10:11:37 x kernel: eth0: PCI bus error, bus status 80000020 | > Jan 23 10:11:37 x kernel: You probably have a hardware problem with your | > RAM chips | > Jan 23 10:11:37 x kernel: eth0: Host error, FIFO diagnostic register | > 0000. | > Jan 23 10:11:37 x kernel: eth0: PCI bus error, bus status 80000020 | > | > The last two messages will repeat indefinitely, usually with a hit to | > the dist for each pair of log entries (resulting in a very distinctive | > drive grinding). Memory problems don't seem to be the issue; with a | > fairly extensive run of memtest86, everything came back clean. | > | > Taking a few minutes to try and rectify the situation, I started | > shutting down services and manually unloading modules to see what was | > causing the problem. Unloading usbcore did the trick: | > | > Jan 26 18:41:24 x kernel: eth0: Host error, FIFO diagnostic register | > 0000. | > Jan 26 18:41:24 x kernel: eth0: PCI bus error, bus status 80000020 | > Jan 26 18:41:24 x kernel: eth0: Too much work in interrupt, status e003. | > Jan 26 18:41:24 x kernel: usb.c: USB disconnect on device 1 | > Jan 26 18:41:24 x kernel: USB bus 1 deregistered | > | > I've rebooted the machine since then, but have always unloaded usb-uhci | > and usbcore after booting. The issue hasn't cropped up again, although | > it happened every couple of days previously. | > | > The kernel in question is Red Hat's kernel-smp-2.4.9-21 build. | > | > -- | > Edward S. Marshall <esm@logic.net> | > http://esm.logic.net/ | > ------------------------------------------------------------------------------- | > [ Felix qui potuit rerum cognoscere causas. | > ] | > | > - | > To unsubscribe from this list: send the line "unsubscribe linux-kernel" in | > the body of a message to majordomo@vger.kernel.org | > More majordomo info at http://vger.kernel.org/majordomo-info.html | > Please read the FAQ at http://www.tux.org/lkml/ | > | | - | To unsubscribe from this list: send the line "unsubscribe linux-kernel" in | the body of a message to majordomo@vger.kernel.org | More majordomo info at http://vger.kernel.org/majordomo-info.html | Please read the FAQ at http://www.tux.org/lkml/ - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/