Unfortunately, the only work-around I found for this problem so far
is to change the hardware to a non intel NIC, or to use the e100 module
from Intel...
Ben
Michael Klose wrote:
> I know there have been mails on this in this list before, the last I
> heard was a month ago and I saw many fixes going into recent kernels.
>
> My contribution is just to say that the problem has gotten worse.
>
> In 2.4.15pre5 (in my opinion one of the most stable 2.4 kernels I have
> tested) it "only" crashed after transferring about 2-3 GB of data via my
> laptop SMB share over the 100MBit switch to the linux server.
> 2.4.17 crashes after 100-200 GB of data transfer.
>
> By crash I mean total freeze. Nothing in the logs at all. Only a reset
> or poweroff will help.
> The server is running on a dual Pentium II BX board (only one PII 266 in
> it though) with 256MB RAM. Also, SMP support is currently NOT compiled in.
>
> I have two intel eepro100 cards in there.
>
> (2.4.17 kernel output)
>
> Jan 4 17:27:34 linux kernel: eth0: OEM i82557/i82558 10/100 Ethernet,
> 00:50:8B:04:6F:CD, IRQ 12.
> Jan 4 17:27:34 linux kernel: Receiver lock-up bug exists -- enabling
> work-around.
> Jan 4 17:27:34 linux kernel: Board assembly 702536-008, Physical
> connectors present: RJ45
> Jan 4 17:27:34 linux kernel: Primary interface chip i82555 PHY #1.
> Jan 4 17:27:34 linux kernel: General self-test: passed.
> Jan 4 17:27:34 linux kernel: Serial sub-system self-test: passed.
> Jan 4 17:27:34 linux kernel: Internal registers self-test: passed.
> Jan 4 17:27:34 linux kernel: ROM checksum self-test: passed
> (0x24c9f043).
> Jan 4 17:27:34 linux kernel: Receiver lock-up workaround activated.
> Jan 4 17:27:34 linux kernel: PCI: Found IRQ 10 for device 00:12.0
> Jan 4 17:27:34 linux kernel: eth1: Intel Corp. 82557 [Ethernet Pro 100]
> (#2), 00:A0:C9:B5:0C:E6, IRQ 10.
> Jan 4 17:27:34 linux kernel: Receiver lock-up bug exists -- enabling
> work-around.
> Jan 4 17:27:34 linux kernel: Board assembly 682704-002, Physical
> connectors present: RJ45
> Jan 4 17:27:34 linux kernel: Primary interface chip i82555 PHY #1.
> Jan 4 17:27:34 linux kernel: General self-test: passed.
> Jan 4 17:27:35 linux kernel: Serial sub-system self-test: passed.
> Jan 4 17:27:35 linux kernel: Internal registers self-test: passed.
> Jan 4 17:27:35 linux kernel: ROM checksum self-test: passed Jan 4
> 17:26:20 linux fsck: reiserfsprogs 3.x.0j
> Jan 4 17:27:35 linux kernel: Receiver lock-up workaround activated.
>
> In between rc.sysinit was running, setting up the clock, atd and
> starting to check filesystems, but I took out those bits of the log.
>
> eth0 is connected to the 100MBit switch which connects to the LAN.
> eth1 is just connected to a DSL modem (10 MBit link).
>
> I have tried switching around the cards, doesn't work.
>
> Apart from that the system runs stable. A two day run of constantly
> compiling kernels while copying several gigabytes between hard disks
> over and over again at the same time did not seem to crash it.
>
> It crashed immediately though as soon as you have HIGH network traffic.
> By that I mean copying several hundred Megabyte to the server. As soon
> as you do this, it crashes every time.
>
> On 2.4.15pre5 it required a lot more data to be transferred to be
> crashed, usually in the 1-2 gigabyte range.
>
> I have an unrelated problem with an ISDN card USR sportster in the
> latest release. It no longer works. It has been working happily for
> years on a 2.0.36 until I upgraded to the new server. It has been
> running fine sinde 2.4.5 (I didn't try earlier kernels on that machine)
> and it still worked fine in 2.4.15pre5. I am not much interested in ISDN
> anymore since I have DSL since a week now. I just wanted to mention it:
>
> Jan 4 17:12:06 linux kernel: ISDN subsystem Rev:
> 1.1.4.1/1.1.4.1/1.1.4.1/1.1.4.1/none/1.1.4.1 loaded
> Jan 4 17:12:06 linux kernel: HiSax: Linux Driver for passive ISDN cards
> Jan 4 17:12:06 linux kernel: HiSax: Version 3.5 (module)
> Jan 4 17:12:06 linux kernel: HiSax: Layer1 Revision 1.1.4.1
> Jan 4 17:12:06 linux kernel: HiSax: Layer2 Revision 1.1.4.1
> Jan 4 17:12:06 linux kernel: HiSax: TeiMgr Revision 1.1.4.1
> Jan 4 17:12:06 linux kernel: HiSax: Layer3 Revision 1.1.4.1
> Jan 4 17:12:06 linux kernel: HiSax: LinkLayer Revision 1.1.4.1
> Jan 4 17:12:06 linux kernel: HiSax: Approval certification failed
> because of
> Jan 4 17:12:06 linux kernel: HiSax: unauthorized source code changes
> Jan 4 17:12:06 linux kernel: HiSax: Card 1 Protocol EDSS1 Id=HiSax (0)
> Jan 4 17:12:06 linux kernel: HiSax: USR Sportster driver Rev. 1.1.4.1
> Jan 4 17:12:06 linux kernel: HiSax: USR Sportster config irq:10 cfg:0x258
> Jan 4 17:12:06 linux kernel: Sportster: ISAC version (0): 2086/2186 V1.1
> Jan 4 17:12:06 linux kernel: Sportster: HSCX version A: V2.1 B: V2.1
> Jan 4 17:12:06 linux kernel: USR Sportster: IRQ 10 count 0
> Jan 4 17:12:06 linux kernel: USR Sportster: IRQ 10 count 0
> Jan 4 17:12:06 linux kernel: USR Sportster: IRQ(10) getting no
> interrupts during init 1
> Jan 4 17:12:06 linux kernel: USR Sportster: IRQ 10 count 0
> Jan 4 17:12:06 linux isdn: Loading ISDN modules succeeded
> Jan 4 17:12:06 linux kernel: USR Sportster: IRQ(10) getting no
> interrupts during init 2
> Jan 4 17:12:06 linux kernel: USR Sportster: IRQ 10 count 0
> Jan 4 17:12:06 linux kernel: USR Sportster: IRQ(10) getting no
> interrupts during init 3
> Jan 4 17:12:06 linux kernel: HiSax: Card USR Sportster not installed !
>
>
> If the ISDN thing is a RTFM thing that I just need to upograde some
> userland tools, then don't worry about it. I no longer need it so I
> doidn't put much research into it. It was just working fine till the new
> driver version came in in 2.4.17.
>
> I am concerned about the eepro issue. I normally love intel network
> cards, they are damn fast and give excellent throughput on Windows NT
> servers and Windows desktop machines. But constantly crashing my server
> is not a good thing.
>
>
>
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at http://www.tux.org/lkml/
>
-- Ben Greear <greearb@candelatech.com> <Ben_Greear@excite.com> President of Candela Technologies Inc http://www.candelatech.com ScryMUD: http://scry.wanfear.com http://scry.wanfear.com/~greear- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/