Re: OOPS: 2.5.1-pre8 - cdrecord + ide_scsi

[Carl Ritson]

> On Sun, Dec 09 2001, Jens Axboe wrote:
> > On Sun, Dec 09 2001, Carl Ritson wrote:
> > > Got this at the very start of burning a cd, nothing special, using
> > > ide-scsi build into kernel. "cdrecord -v dev=0,0,0 speed=4 img.iso".
> > > Box is Dual-PIII 866, 1GB Ram, all IDE system.
> >
> > Agrh, because of a bug in ide-scsi conversion this (other) bug went
> > unnoticed for a while. Basically we cannot look up the request queue
> > reliably from a request, since it may not have originated from the block
> > layer. ide-scsi builds it's own, for example. For those, we don't want
> > to trust the sg count either.
> >
> > Does attached patch work?
>
> Irk, there's a ide-scsi bug in there too. In
> drivers/scsi/ide-scsi.c:idescsi_free_bio() change the kfree(bhp) to
> bio_put(bhp)
>

With both these fixes applied cdrecord hangs for 30 seconds, then spits
out "cdrecord: No such device or address. Cannot send SCSI cmd via ioctl",
a couple of hundred times.

In the from dmesg from the same time I get.
------
hdc: timeout waiting for DMA
ide_dmaproc: chipset supported ide_dma_timeout func only: 14
hdc: status error: status=0x58 { DriveReady SeekComplete DataRequest }
hdc: drive not ready for command
scsi: device set offline - command error recover failed: host 0 channel 0
id 0 lun 0
------

So no joy yet. :/

Carl Ritson
[e-mail]