Re: Using %cr2 to reference "current"

[Manfred Spraul]

Robert Love wrote:
> 
> Further, the preemptible kernel patch oopses with this patch (IOW, don't
> use 2.4.13-ac8 + preempt-kernel, unless you remove all these bits like I
> did :>).  I think it may be because of:
>

Could you send me an oops?
I assume that a
	set_current(hard_get_current());
is missing somewhere.
The assumption is that get_current() is faster than hard_get_current(),
and that there are so many get_current() calls that the overhead for the
set_current() in __switch_to and do_page_fault is small.

> Manfred Spraul wrote:
> > error_code:
> > [...]
> > -       GET_CURRENT(%ebx)
> >         call *%edi
> >         addl $8,%esp
> > +       GET_CURRENT(%ebx)
> > The pointer to current was loaded into %ebx before the call to the error
> > handler, now that only happens after the call. As far as I can see the
> > load before the call is not required.
> 
> this change but I am unsure.  Would Manfred or someone knowledgeable in
> this mind letting me pick their brain?
>
I would be very surprised if that's a problem: the error handlers are C
functions, and they don't expect parameters in register %ebx.

--
	Manfred