Re: Poor IDE performance with VIA MVP3

[Ryan Hayle]

On Mon, 05 Nov, 2001 at 03:10:01PM -0500, Mark Hahn wrote:
> > I have a VIA MVP3 (VT82C586B) controller on my motherboard, and am
> 
> an inherently slow chipset, with at best 150 MB/s dram throughput.
> 
> > experiencing extremely poor performance with a Maxtor 20G
> > (52049U4) drive.  
> 
> 20G, 4 surfaces, 10G/platter generation, from around 2-3 years ago.
> (versus 40G/platter current gen.)
> 
> > It is an UDMA66-capable drive, but I'm only attempting
> > to use UDMA33 (with an 80-pin cable, as recommended).
> 
> nothing wrong with an 80-conductor cable, but it's not required
> for udma33.
> 
> > same behavior.  I was originally running with a 40-pin cable, and switched
> > it to the 80 to see if it might help, but it had no effect.  As some
> 
> is it <18", with both ends plugged in? 
> 
> > Cable Type:                   40w                 40w
> 
> hmm.

The cable is of standard length, which I believe is 18".  It came with the
drive.  I only have one drive plugged into it.  I thought it was odd tha
/proc/ide/via only showed the cable as 40w also, but I assumed that was
because my chipset doesn't know what 80-pin cables are...am I wrong?  In
any case, it's sounding more and more that there's not much I can do to
remedy this problem. :/  Oh well, I'm probably due for a motherboard
upgrade in any case.

Thanks,
Ryan