Re: linux-2.4.12 / linux-2.4.13 parallel port problem

[bill davidsen]

In article <[e-mail]>,
Dave Garry <[e-mail]> wrote:
| 
| Tim Waugh wrote:
| > 
| > On Wed, Oct 24, 2001 at 04:02:00PM +0100, Dave Garry wrote:
| > 
| > > Thanks for the tip, but it's not helping. I've tried
| > > "irq=auto" and "irq=7" but it still wont play.
| > >
| > > I just noticed that CONFIG_PARPORT_PC_FIFO is set to NO
| > > and I'm rebuilding with it set to YES to see if that
| > > helps...
| > 
| > Yes, you need that enabled or it won't even have the code for using
| > the FIFO compiled in.
| 
| Enabling CONFIG_PARPORT_PC_FIFO has not helped, I now
| get the following:
| 
| # modprobe parport_pc verbose_probing=1 irq=auto

Curious. I Get rejected when I use irq=auto with 2.4.13-pre6.

#================ config
# Parallel port support
#
CONFIG_PARPORT=m
CONFIG_PARPORT_PC=m
CONFIG_PARPORT_PC_CML1=m
# CONFIG_PARPORT_SERIAL is not set
CONFIG_PARPORT_PC_FIFO=y
# CONFIG_PARPORT_PC_SUPERIO is not set
# CONFIG_PARPORT_AMIGA is not set
# CONFIG_PARPORT_MFC3 is not set
# CONFIG_PARPORT_ATARI is not set
# CONFIG_PARPORT_SUNBPP is not set
# CONFIG_PARPORT_OTHER is not set
CONFIG_PARPORT_1284=y
#================

I did set 1284 mode, and assume you have as well. I don't have super-io
set, since I have an old chipset, perhaps that's an issue as well.

-- 
bill davidsen <[e-mail]>
  His first management concern is not solving the problem, but covering
his ass. If he lived in the middle ages he'd wear his codpiece backward.