> > hub.c: USB new device connect on bus1/2, assigned device number 2
> > usb_control/bulk_msg: timeout
> > usb.c: USB device not accepting new address=2 (error=-110)
>
> Could you give me the output of /proc/interrupts?
CPU0 CPU1
0: 71555 64454 IO-APIC-edge timer
1: 1355 1274 IO-APIC-edge keyboard
2: 0 0 XT-PIC cascade
5: 0 0 IO-APIC-edge NE2000
14: 4157 5136 IO-APIC-edge ide0
15: 2 19 IO-APIC-edge ide1
16: 2462 2381 IO-APIC-level eth0
17: 0 0 IO-APIC-level Trident 4DWave NX
18: 1 1 IO-APIC-level bttv
19: 2330 2467 IO-APIC-level aic7xxx, usb-uhci
NMI: 0 0
LOC: 135894 135912
ERR: 0
MIS: 0
> Do you see any other messages in dmesg?
Here is an entire "insmod uhci" output:
uhci.c: USB Universal Host Controller Interface driver v1.1
uhci.c: USB UHCI at I/O 0xb400, IRQ 19
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
hub.c: USB new device connect on bus1/2, assigned device number 2
usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address=2 (error=-110)
hub.c: USB new device connect on bus1/2, assigned device number 3
usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address=3 (error=-110)
> What UHCI controller is this? (lspci -v)
00:04.2 USB Controller: Intel Corporation 82371AB PIIX4 USB (rev 01) (prog-if 00 [UHCI])
Flags: bus master, medium devsel, latency 32, IRQ 19
I/O ports at b400 [size=32]
It's on an ASUS P2B-DS (with broken USB resistor shorted).
Simon-
[ Stormix Technologies Inc. ][ NetNation Communications Inc. ]
[ sim@stormix.com ][ sim@netnation.com ]
[ Opinions expressed are not necessarily those of my employers. ]
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/