Re: lpr to HP laserjet stalls

[Michael Ben-Gershon]

Tim Waugh wrote:
> 
> On Tue, Sep 04, 2001 at 02:21:31PM +0300, Michael Ben-Gershon wrote:
> 
> For interrupt-driven mode: irq=auto dma=nofifo
> For PIO mode: irq=auto dma=none
> For DMA mode: irq=auto dma=auto
> 
> You need to check the 'dmesg' output after parport_pc has loaded to
> see exactly what it will use though (i.e. whether it has detected
> usable hardware).
> 
> The line that goes 'parport0: PC-style at 0x378 (0x778)' is the
> important one.  Ignore the stuff in [brackets] at the end; if an
> interrupt is mentioned it is using it; if a DMA channel is mentioned,
> it is using it; and if it says 'using FIFO' then it's using the FIFO
> with programmed IO (rather than DMA).

OK. Firstly I rebuilt the kernel (2.4.9) with CONFIG_PARPORT_PC_FIFO
enabled. I also configured the parallel driver to be a module, to enable
easier testing.

I found that whatever I did, printing was not stalled (this must be a
result of CONFIG_PARPORT_PC_FIFO).

However, I found that dmesg gave some strange messages every so often under
PIO and DMA modes.

	FIFO is stuck
	BUSY timeout
	dma write timed out

I don't know what they mean (the printing itself was not affected) but
I guess it would be better to avoid modes which give such messages.

At the moment I am loading the module with:

	insmod parport
	insmod parport_pc io=0x378,0xa800 irq=auto,auto dma=nofifo,nofifo

If there is anything more I should be doing, please let me know.

Thanks for all the help,

Michael Ben-Gershon
[e-mail]