Re: 3c509: broken(verified)

[Nico Schottelius]

Alan Cox wrote:

> > The driver for the 3c509 of 2.4.7 is broken:
> > It is impossible to set the transmitter type.
> > modprobe 3c509 xcvr=X, where X is
> > 0,1,2,3,4 doesn't make a difference.
>
> Looking at the code it should set the type fine. The only bug I can see is
> that it will report the default type set in the eeprom not the type you
> asked.
>
> If thats the case (please check) then its trivial to fix

While I tried to setup the driver I always let one machine
outside ping it.

It is not just the message.

ozean:~ # modprobe 3c509 ; ifconfig eth1 192.168.4.17 up

eth1: 3c5x9 at 0x360, BNC port, address  00 60 97 39 43 b9, IRQ 5.
3c509.c:1.18 12Mar2001 [e-mail]
http://www.scyld.com/network/3c509.html

- the light on the hub keeps off, no ping answer

ozean:~ # ifconfig eth1 down ; rmmod 3c509;

ozean:~ # modprobe 3c509 xcvr=4 debug=4

## xcvr=4 is TP (found on scyld.com/network/3c509.html)

3c509.c:1.18 12Mar2001 [e-mail]
http://www.scyld.com/network/3c509.html
eth1: Setting Rx mode to 1 addresses.
  3c509 EEPROM word 7 0x6d50.
  3c509 EEPROM word 0 0x0060.
  3c509 EEPROM word 1 0x9739.
  3c509 EEPROM word 2 0x43b9.
  3c509 EEPROM word 8 0xc096.
  3c509 EEPROM word 9 0x5000.

eth1: 3c5x9 at 0x360, BNC port, address  00 60 97 39 43 b9, IRQ 5.
3c509.c:1.18 12Mar2001 [e-mail]
http://www.scyld.com/network/3c509.html
  3c509 EEPROM word 7 0xffff.
eth1: Opening, IRQ 5     status@36e 0000.
eth1: Opened 3c509  IRQ 5  status 2000.
eth1: Setting Rx mode to 1 addresses.

ozean:~ # ifconfig eth1 192.168.4.17 up

- ping does not work, no light is seen

That's it! The cable & the hub are okay.

Nico