Re: eepro100 problems with 2.2.19 _and_ 2.4.0

[Jeff Chua]

Try to add "options eepro100 options=0" to your /etc/modules.conf
to default the speed to 10Mbps if you're using 10BaseT.

add to /etc/modules.conf ...
# options=0x30 100mbps full duplex
# options=0x20 100mbps half duplex
# options=0     10mbps half duplex
options eepro100 options=0

then run "depmod -a"

Thanks,
Jeff
[ [e-mail] ]
----- Original Message ----- 
From: "Christian Robottom Reis" <[e-mail]>
To: <[e-mail]>
Cc: <[e-mail]>; <[e-mail]>
Sent: Sunday, June 17, 2001 10:43 AM
Subject: Re: eepro100 problems with 2.2.19 _and_ 2.4.0

Just noticed:

On Sat, 16 Jun 2001, Christian Robottom Reis wrote:

> Steps to reproduce problem:
>
> * Run large ( > 2MB works ) ftp transfer in box.
> * ssh in from another box and attempt an ls -lR /

Note below:

> * 2.2.19 with Donald's eepro100.c scyld:network/
> Hard lock (seems to take longer to hang) - it also creates
> 8 devices eth0-eth7!
>
> * 2.2.19 with Donald's eepro100.c fromscyld:network/test/
> Hard lock (pretty fast) - no multiple creation bugs

Actually, they don't hang _immediately_. They report:

eth0: Transmit timed out: status 0050  0000 at 6022/6034 commands 000c0000
000c0000 000c0000
Command 0000 was not immediately accepted, 10001 ticks!

And the ssh connection stalls but does on trying (it eventually hangs, but
not after a lot of errors are reported on the problem-box's console)

And then the box hard locks. Interesting to see that only when I run the
ssh ls -lR is that any error at all is produced. The lockups I was seeing
were all interactive use and I never really noticed if errors were showing
up or not; I just assumed they weren'.

Any help you can provide is very much appreciated. I'm about to try
Intel's drivers to see how they do.

Take care,
--
/\/\ Christian Reis, Senior Engineer, Async Open Source, Brazil
~\/~ http://async.com.br/~kiko/ | [+55 16] 274 4311