Re: Kernel 2.4.4, Adaptec 7880 on board controller

Andrzej Krzysztofowicz (ankry@pg.gda.pl)
Fri, 11 May 2001 08:19:35 +0200 (MET DST)


"Joachim Backes wrote:"
> when booting on a machine having an Adaptec 7880 on board
> controller (Kernel 2.4.4), then i get the following msg:
> ...
> SCSI subsystem driver Revision: 1.00
> request_module[scsi_hostadapter]: Root fs not mounted
> request_module[scsi_hostadapter]: Root fs not mounted
> request_module[scsi_hostadapter]: Root fs not mounted
> ...
> The aic7xxx scsi driver is not configured as module,
> but linked to the kernel.

Hmmm, I observe similar messages when
- scsi low-level driver (eg. sd, sr, st) linked to the kernel,
- no appropriate (corresponding to any of the above drivers) devices found
on the hostadapters which have support linked to the kernel.

I don't think it is driver-specyfic. As I looked at the code it would be
difficult to avoid them (unless a linked-to-the-kernel function is able
to detect whether it is called from __init code or from a module
initialization code).

-- 
=======================================================================
  Andrzej M. Krzysztofowicz               ankry@mif.pg.gda.pl
  phone (48)(58) 347 14 61
Faculty of Applied Phys. & Math.,   Technical University of Gdansk

- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/