Subject says it all.
With latest updates, i just deleted the kernel aic7xxx subtree, put instead
the updated (from people.freebsd.org) tree, and built. All went fine
until (and including) 6.1.9.
6.1.10 just stops after the init messages and stays there forever.
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.1.9
<Adaptec aic7890/91 Ultra2 SCSI adapter>
aic7890/91: Wide Channel A, SCSI Id=7, 32/255 SCBs
(6.1.10 stops here)
Vendor: IBM Model: DCAS-34330W Rev: S65A
Type: Direct-Access ANSI SCSI revision: 02
scsi0:0:0:0: Tagged Queuing enabled. Depth 253
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
(scsi0:A:0): 40.000MB/s transfers (20.000MHz, offset 15, 16bit)
SCSI device sda: 8467200 512-byte hdwr sectors (4335 MB)
Partition check:
sda: sda1 sda2 < sda5 sda6 sda7 sda8 >
-- J.A. Magallon # Let the source mailto:jamagallon@able.es # be with you, Luke...Linux werewolf 2.4.3-ac3 #1 SMP Thu Apr 5 00:28:45 CEST 2001 i686
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/