Re: eepro100 question: why SCBCmd byte is 0x80?

[Steven Walter]

I'm having a similar problem with the onboard network card of a Sony
Vaio Laptop.  I haven't tracked it down as far as you can; how can I
confirm its the same problem as yours?

On Fri, Mar 23, 2001 at 09:34:36AM -0800, Jun Sun wrote:
> christophe barbe wrote:
> > 
> > Which kernel are you using.
> > 
> > I've had a similar problem with 2.2.18.
> > I've backported 2.2.19pre changes to it.
> > (i.e. apply on 2.2.18 a diff of the file drivers/net/eepro100.c made between 2.2.18 and the last 2.2.19pre)
> > And since I've never seen this problem again.
> > 
> > Christophe
> > 
> 
> Kernel is 2.4.2.  It is a MIPS machine.
> 
> I don't really think it is a driver problem, because the same dirver works
> fine on many other boards (including MIPS boards).  In addition, I also tested
> with tulip cards and I had the same symptom.  I am convinced it is a low-level
> problem (bus timing, PCI setting, buggy hardware, etc).
> 
> On the other hand, it could be a driver problem which is only exposed in this
> particular board, although very unlikely.
> 
> BTW, does the eepro100 patch for 2.2.19pre apply to 2.4.2?  Or it is already
> in it?
> 
> Thanks.
> 
> Jun
> 
> > On jeu, 22 mar 2001 22:04:45 Jun Sun wrote:
> > >
> > > I am trying to get netgear card working on a new (read as potentially buggy
> > > hardware) MIPS board.
> > >
> > > The eepro100 driver basically works fine.  It is just after a little while
> > > (usually 2 sec to 15 sec) network communication suddenly stops and I start see
> > > error message like "eepro100: wait_for_cmd_done timeout!".
> > >
> > > I looked into this, and it appears that the SCBCmd byte in the command word
> > > has value 0x80 instead of the expected 0.  I looked at the Intel manual, and
> > > it says nothing about the value being 0x80.
> > >
> > > Does anybody have a clue here?  I suspect some timing is wrong or a buggy PCI
> > > controller.
> > >
> > > Please cc your reply to my email address.  Thanks.
> > >
> > > Jun
> > > -
> > > To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> > > the body of a message to [e-mail]
> > > More majordomo info at  http://vger.kernel.org/majordomo-info.html
> > > Please read the FAQ at  http://www.tux.org/lkml/
> > >
> > --
> > Christophe Barbé
> > Software Engineer
> > Lineo High Availability Group
> > 42-46, rue Médéric
> > 92110 Clichy - France
> > phone [phone]
> > fax [phone]
> > www.lineo.com
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to [e-mail]
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at  http://www.tux.org/lkml/

-- 
-Steven
Freedom is the freedom to say that two plus two equals four.