I've had a similar problem with 2.2.18.
I've backported 2.2.19pre changes to it.
(i.e. apply on 2.2.18 a diff of the file drivers/net/eepro100.c made between 2.2.18 and the last 2.2.19pre)
And since I've never seen this problem again.
Christophe
On jeu, 22 mar 2001 22:04:45 Jun Sun wrote:
>
> I am trying to get netgear card working on a new (read as potentially buggy
> hardware) MIPS board.
>
> The eepro100 driver basically works fine. It is just after a little while
> (usually 2 sec to 15 sec) network communication suddenly stops and I start see
> error message like "eepro100: wait_for_cmd_done timeout!".
>
> I looked into this, and it appears that the SCBCmd byte in the command word
> has value 0x80 instead of the expected 0. I looked at the Intel manual, and
> it says nothing about the value being 0x80.
>
> Does anybody have a clue here? I suspect some timing is wrong or a buggy PCI
> controller.
>
> Please cc your reply to my email address. Thanks.
>
> Jun
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at http://www.tux.org/lkml/
>
-- Christophe Barbé Software Engineer Lineo High Availability Group 42-46, rue Médéric 92110 Clichy - France phone (33).1.41.40.02.12 fax (33).1.41.40.02.01 www.lineo.com - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/