The eepro100 driver basically works fine. It is just after a little while
(usually 2 sec to 15 sec) network communication suddenly stops and I start see
error message like "eepro100: wait_for_cmd_done timeout!".
I looked into this, and it appears that the SCBCmd byte in the command word
has value 0x80 instead of the expected 0. I looked at the Intel manual, and
it says nothing about the value being 0x80.
Does anybody have a clue here? I suspect some timing is wrong or a buggy PCI
controller.
Please cc your reply to my email address. Thanks.
Jun
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/