Mark Hahn <hahn@coffee.psychology.mcmaster.ca> writes:
> > Greetings! Two ide tapes, both on second ide channel, both using
>
> mixing devices from different vendors on the same channel
> often gives this kind of problem. sticking in even a cheap
> PCI ide controller would pretty dramatically improve your
> system (since you could put one device on each channel).
>
>
Good advice, but the problem persists even when the offending drive is
alone on the secondary ide channel. In fact, this the configuration
in which I first came upon the problem. I installed the second drive
later, and when that worked, I suspected a model-specific bug in the
driver.
One gets an analogous kernel error when using the straight ide-tape
driver.
Take care,
>
> > ide-scsi. One works perfectly, the other basically works, but gives
> > errors, and occasionally doesn't write full 32k blocks to tape,
> > causing amanda errors.
> >
> > Feb 25 06:14:22 intech9 kernel: ALI15X3: IDE controller on PCI bus 00 dev 78
> > Feb 25 06:14:22 intech9 kernel: ALI15X3: not 100%% native mode: will probe irqs later
> > Feb 25 06:14:22 intech9 kernel: ide0: BM-DMA at 0xb400-0xb407, BIOS settings: hda:DMA, hdb:DMA
> > Feb 25 06:14:22 intech9 kernel:
> > Feb 25 06:14:22 intech9 kernel: ************************************
> > Feb 25 06:14:22 intech9 kernel: * ALi IDE driver (1.0 beta3) *
> > Feb 25 06:14:22 intech9 kernel: * Chip Revision is C1 *
> > Feb 25 06:14:22 intech9 kernel: * Maximum capability is - UDMA 33 *
> > Feb 25 06:14:22 intech9 kernel: ************************************
> > Feb 25 06:14:22 intech9 kernel:
> > Feb 25 06:14:22 intech9 kernel: ide1: BM-DMA at 0xb408-0xb40f, BIOS settings: hdc:pio, hdd:pio
> > Feb 25 06:14:22 intech9 kernel: hda: FUJITSU MPE3064AT, ATA DISK drive
> > Feb 25 06:14:22 intech9 kernel: hdb: ST32140A, ATA DISK drive
> > Feb 25 06:14:22 intech9 kernel: hdc: CONNER CTT8000-A, ATAPI TAPE drive
> > Feb 25 06:14:22 intech9 kernel: hdd: HP COLORADO 14GB, ATAPI TAPE drive
> > Feb 25 06:14:22 intech9 kernel: ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> > Feb 25 06:14:22 intech9 kernel: ide1 at 0x170-0x177,0x376 on irq 15
> > Feb 25 06:14:22 intech9 kernel: ALI15X3: Ultra DMA enabled
> > Feb 25 06:14:22 intech9 kernel: hda: FUJITSU MPE3064AT, 6187MB w/512kB Cache, CHS=788/255/63, (U)DMA
> > Feb 25 06:14:22 intech9 kernel: ALI15X3: MultiWord DMA enabled
> > Feb 25 06:14:22 intech9 kernel: hdb: ST32140A, 2015MB w/128kB Cache, CHS=4095/16/63, DMA
> > Feb 25 06:14:22 intech9 kernel: hda: hda1 hda2 hda3 hda4 < hda5 hda6 hda7 >
> > Feb 25 06:14:22 intech9 kernel: hdb: hdb1 hdb2
> >
> > The Conner gives the problem:
> >
> > Feb 27 06:23:16 intech9 kernel: st0: Error with sense data: [valid=0] Info fld=0x0, Current st09:00: sns = 70 5
> > Feb 27 06:23:16 intech9 kernel: ASC=20 ASCQ= 0
> > Feb 27 06:23:16 intech9 kernel: Raw sense data:0x70 0x00 0x05 0x00 0x00 0x00 0x00 0x0a 0x00 0x00 0x00 0x00 0x20 0x00 0x00 0x00
> >
> > and occaisional 'gunzip: unexpected end of file' errors on verifying
> > the tape.
> >
> > Take care,
> >
> >
> >
>
> --
> operator may differ from spokesperson. hahn@coffee.mcmaster.ca
> http://java.mcmaster.ca/~hahn
>
>
>
-- Camm Maguire camm@enhanced.com ========================================================================== "The earth is but one country, and mankind its citizens." -- Baha'u'llah - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/