Re: digiboard support in linux

[Martin Laberge]

Kenneth Yeung wrote:

> Hello Martin
>
>         Thanks for the info, I'm having a little trouble getting the ports
> configured.  On my system, it looks like half the ports are on irq 2 and
> the other half are on irq 5.  and looks like they have been configured the
> right way?  But i can't seem to get them to run getty so that I can test
> the connection.
>
> Thanks!
> -Ken
>
> On Tue, 30 Jan 2001, Martin Laberge wrote:
>
> > Kenneth Yeung wrote:
> >
> > > Hello all
> > >
> > > Can anyone tell me where I can find infomation on digiboard support in
> > > linux specifically the PC/X model?
> > >
> > > THanks
> > > -Ken
> > >
> > > -
> > > To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> > > the body of a message to [e-mail]
> > > Please read the FAQ at http://www.tux.org/lkml/
> >
> > yes i used it often in my installations and no problem with that
> > since 2.0.x
> >
> > 2.2.x works good too
> >
> > never tried with linux 2.4.x
> >
> >
> > driver is supported by digiboard itself   and by linux
> >
> > you have the choice of 2 drivers for these boards....
> >
> > i used for my part the PC/8e  PC/16e and PC/32e   In ISA versions
> > and never had any problems... (except figuring out how to install for the
> > first time)
> > but it is very simple if you know how to read install instructions
> >
> >
> > Martin Laberge
> > [e-mail]
> >
> >
> >

could you send me the configuration logs and system boot messages about the
digiboard...

for my part i used agetty on these ports and the board use only one interrupt
(exept if you have many boards...
in that case one interrupt by board ... )

did you executed the DigiLoad command in your boot scripts like instructed in
documentations...
did you put the board drivers (?????.bin) in the right places...

they have to be loaded for the board to work...

Martin Laberge
[e-mail]