Re: Matrox G450 problems with 2.4.0 and xfree

[Petr Vandrovec]

On 31 Jan 01 at 8:44, David Woodhouse wrote:
> On Tue, 30 Jan 2001, Marcel J.E. Mol wrote:
> 
> > Installed a Matrox G450 on my linux system. Now it has problems
> > booting.
> > 
> > Previously I had a matrox G400 card and that worked without any problems.
> > 
> > Below follows .config for the 2.4.0 kernel.
> > 
> > # CONFIG_FB_MATROX_G450 is not set

It is only for secondary head support - and all code which is guarded
by this define is executed after lockup occurs, so no, it is not the 
reason why it works / does not work...

If it helped you, I think that rule (4) from my another posting
applies to you - you are just lucky...

I asked matrox devrel again, but no answer. And linking matroxfb with 
512KB binary-only mgaHALlib.a is unacceptable personally for me, not
even talking about license issues... (and not talking about technical
problems with getting mgaHALlib to work in kernel environment...)
                                                Best regards,
                                                    Petr Vandrovec
                                                    [e-mail]