Re: No SCSI Ultra 160 with Adaptec Controller

Tim Sullivan (tsulliva@iex.net)
Tue, 23 Jan 2001 23:43:29 -0700

Matt_Domsch@Dell.com wrote:
>
> Yes, that code is still necessary. There's a new aic7xxx driver by Justin
> Gibbs at Adaptec which is now being beta tested which corrects this issue.

Justin's 6.0.9beta(latest release) hasn't corrected the problem yet.

scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.0.9 BETA
<Adaptec 29160 Ultra160 SCSI adapter>
aic7892: Wide Channel A, SCSI Id=7, 32/255 SCBs

Vendor: QUANTUM Model: ATLAS10K2-TY367L Rev: DDD6
Type: Direct-Access ANSI SCSI revision: 03
(scsi0:A:0): async, 8bit
scsi0:0:0:0: Tagged Queuing enabled. Depth 8
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
(scsi0:A:0): async, 16bit
(scsi0:A:0): synchronous at 80.0MHz DT, offset 0x7f, 16bit
SCSI device sda: 71721820 512-byte hdwr sectors (36722 MB)

-tim
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
Please read the FAQ at http://www.tux.org/lkml/