Re: Linux booting from HD on Promise Ultra ATA 100

Martin Josefsson (gandalf@wlug.westbo.se)
Fri, 12 Jan 2001 20:30:07 +0100 (CET)


On Fri, 12 Jan 2001, Stephen Torri wrote:

> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
>
> On Fri, 12 Jan 2001, Martin Josefsson wrote:
>
> > My setup looks like this, I boot from hde
> > I configured my BIOS to boot from SCSI (I have no scsi-adapter but the
> > promise card reports itself as one at boottime)
> >
> > boot = /dev/hde3
> > delay = 50
> > message = /boot/message
> > vga = extended
> > read-only
> > lba32
> > disk=/dev/hde
> > bios=0x80
>
>
> The line "lba32" is for what? I have to ask this because I have never seen
> it in an example of a lilo.conf file before.

it is a BIOS extension that allows you to boot of a partition thats
located above cylinder 1024. I think it's called EDB or something like
that.

> Also you put "disk=/dev/hde and bios=0x80" to inform lilo that there was a
> disk there and its bios address is 0x80. Is this right?

yes.

> If I would follow your example then I would put:
>
> lba32
> disk=/dev/hdf
> bios=0x82

I think that would be correct yes, and install LILO on hde (I think the
promise-card only tries to boot from primary master when you have selected
SCSI in BIOS. But I'm not sure.

/Martin

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
Please read the FAQ at http://www.tux.org/lkml/