I can only share from my experience but I've always used the drivers
supplied in the kernel. I've removed one disk in a RAID1 mirror and
had this reported by 3dm.
Took longer then I thought, but after approx 60 seconds, a report was
generated
and subsequent calls to 3dm reported the array as "unsafe".
This is under 2.2.15pre[5] + ide patches.
3dm works under pre20 + ide patches but I have not tested to remove
disks.
FYI, I also used 3ware under 2.3.99.x (crashes kernel under heavy IO,
eg,
streaming 40 MB/s from a RAID0 array). For some reason linux defaults
the
PCI latency to 0 causing very bad performance. Setting latency to 0x40
using
setpci fixes this.
What do you mean by "not working"?
Ove
-- Ove Ewerlid Email: Ove.Ewerlid@[syscon|signal|material].uu.se Phone: +46 70 666 23 63, Fax: +46 18 503 611, +46 18 555 096- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/