http://www.uwsg.indiana.edu/hypermail/linux/kernel/0109.3/0033.html
Results:
2.4.10 performance is great compared to 2.4.[7-9], but these tests
still seem to point out some room for improvement in the 2.4.10 VM tree.
2.4.10 and 2.4.10(+00_vm-tweaks-1) performed similarly. The vm-tweaks
patch improved the swap smoothness, but the number of pages swapped out
didn't change measurably, nor did the large number of swap-ins. Clogging
the system with dirty pages via 'dd' still causes XMMS to skip badly.
Let's push the aging/list-order code more by driving the system a bit
harder in step d), namely adding mozilla to the common user application
test. We will also stream mp3 audio throughout the entire test.
2.4.10(+00_vm-tweaks-1)
48 sec StarOffice load time
28 sec 2560x2560 GIMP image rotation
82400 KB swapped out, 92148 KB swapped back in
2.4.9-ac14 + aging
33 sec StarOffice load time
25 sec GIMP image rotation
30072 KB swapped out, 22252 KB swapped back in
2.4.9-ac15 + aging + launder
33 sec StarOffice load time
24 sec GIMP image rotation
57556 KB swapped out, 25900 KB swapped back in
'vmstat 1' sessions for these three cases are available at:
http://loke.as.arizona.edu/~ckulesa/kernel/
2.4.10+ is clearly working a LOT harder to keep dentry and inode caches
in memory, and is swapping out harder to compensate. The ac14/ac15 tree
frees those caches more freely, and don't page application working sets
out so readily.
Let's test this statement by not pre-filling the inode and dentry caches
with 'slocate' and performing the same test:
2.4.10(+00_vm-tweaks)
26 sec StarOffice load time
24 sec GIMP image rotation
48332 KB swapped out, 33521 KB swapped back in
2.4.9-ac14 + aging
32 sec StarOffice load time
26 sec GIMP image rotation
37392 KB swapped out, 11952 KB swapped back in
2.4.9-ac15 + aging + launder
32 sec StarOffice load time
22 second GIMP image rotation
23884 KB swapped out, 10828 KB swapped back in
2.4.10 does much better this time; in particular the StarOffice loading
that was so plagued by swapouts, pressured by dentry/inode caching last
time, went smoothly. But there's still more paging than with
2.4.9-ac1[4-5].
Let's try one more aging/list-order experiment. Instead of creating a
2560x2560 GIMP image first, then loading StarOffice and many other
applications after (to start swapping, and cause GIMP pages to be
candidates for reaping) -- this time let's load StarOffice first and then
create the GIMP image. This should keep the GIMP image at a 'younger' age
and presumably shouldn't page back into memory (rotation should be
faster). StarOffice may swap itself entirely out however.
2.4.10(+00_vm-tweaks)
25 sec StarOffice load time
29 sec GIMP image rotation
64427 KB swapped out, 77422 KB swapped back in
2.4.9-ac14 + aging
30 sec StarOffice load time
24 sec GIMP image rotation
22147 KB swapped out, 8922 swapped back in
2.4.9-ac15 + aging + launder
31 sec StarOffice load time
21 second GIMP image rotation
17204 KB swapped out, 8224 swapped back in
The 2.4.10 behavior surprised me. The GIMP pages are younger in memory,
yet the rotation was slowed by swapin & swapout activity -- slower than
before. Plus more StarOffice pages were swapped out, so it had to be paged
back in order to close the application. I'm puzzled. The ac14/ac15
behavior was closer to what I expected; the GIMP pages were young and
unswapped, only the earliest StarOffice pages had to be recalled.
These are samples of rather 'ordinary' loads which 2.4.10 needs some work
handling; the ac15 tree is doing a better job with this particular set
right now (ac15 tree also doesn't skip XMMS with the creation of lots of
dirty pages via 'dd'). But all three kernels tested kept the user
interface relatively responsive, which is an improvement over previous
2.4 releases. Very cool.
A note on page_launder(). ac14 has the smoothest swapping, with small
chunks laundered at a time. ac14+aging and ac15+aging+launder both swap
out huge (10-20 MB) chunks at a time. Admittedly, the user interface is
responsive and XMMS doesn't skip a beat, but most of the 60 MB of
actual swapout in the first test in ac15+stuff came from only THREE
lines of 'vmstat 1' output. Otherwise there was no swapout activity.
Best regards, and thanks for the excellent work!
Craig Kulesa
Steward Observatory, Univ. of Arizona
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/